Notice LENCO TFT-721

« or Output 11 7.3 External power supply 12 2 GENERAL INFORMATION ABOUT THE TFT-721 TFT-721 is a portable digital TV set; it can be used in a car or outdoor. Throughout this manual you will notice that everyday operation of your TFT-721 is based on a series of user friendly on-screen displays and menus. These menus will help you get the most from your TFT-721, guiding you through installation, channel selection, viewing and many other functions. Using the buttons on the remote control can perform all functions, and using the buttons on the front panel can also perform some of the functions. Please be aware that new software may change the functionality of the TFT-721. Should you experience any difficulties with the operation of your TFT-721, please consult the relevant section of this manual, including the Troubleshooting, or alternatively call your dealer or customer service adviser. IMPORTANT! Read this before using the TFT-721! Do not cover the TFT-721’s ventilation openings with items such as newspapers, tablecloths, curtains etc. Do not place the TFT-721 on top of a unit that emits heat. Do not place naked flame sources, such as lighted candles, on the TFT-721. Use a soft cloth and a mild solution of washing-up liquid to clean the casing. Do not expose the TFT-721 to dropping or splashing liquids. Do not place any objects filled with liquids, such as vases, by the TFT-721. To give your TFT-721 an extra protection, e.g. at a thunderstorm, we recommend that connect it via an external surge protection device. Do not remove the cover. Do not allow the unit to be exposed to hot, cold or humid conditions. QUICK GUIDE Plug in your TFT-721 You can use either an AC adapter or a rechargeable Li-ion battery as a power source for your TFT-721. Use the TFT-721 only with the supplied AC adapter. To use the AC adapter: 1. Plug one end of the power cord into the AC adapter. 2. Plug the other end of the power cord into an AC outlet. 3. Plug the cable attached to the AC adapter into the DC in port on the TFT-721. Preparing the Remote Control Before using the remote controller, you need to insert the supplied battery in order to enable communication between the TFT-721 and remote controller. To insert battery: Turn the remote controller over. Press in the tab and lift the battery cover up. Insert the supplied battery into the remote controller. Align the battery cover to the remote controller. Press down until the cover clicks into place. ! If the remote controller does not operate properly, you may need to replace the battery. When the remote controller is not being used for extended periods of time, remove the batteries to avoid possible damage from battery leakage. 1. PANELS 1.1 Front panel and side panels 2 1 8 7 6 5 9 3 10 11 4 1. Portable receiving antenna (the antenna jack can plug the accessorial antenna) 2. Front panel buttons (include Ok, Cursor up, Cursor down, Cursor left, Cursor right, Menu, Mode, 16:9/4:3) 3. Screen 4. Infrared remote receiver 5. Headphone jack 6. Video output jack (CVBS) 7. Power supply jack 8. Upgrade jack 9. Indicators (Red, Green, Blue) The states are shown as: Red, green, blue – Machine turn on and charge battery Green – Machine turn on, no charge Red, blue – Machine turn off and charge battery Null – Machine t... »