Notice ENERGY SISTEM Unniversal 2100

« r of battery required stated at the back of the coversheet. 1.Remove the battery cover on the back of your URC. 2.Observe the polarity of the batteries and the “+/–” marks inside the battery compartment. 3.Insert the batteries. 4.Push the battery cover back in place. Battery Low If the indicator flashes twice slowly after your invoking of any command, it shows that the battery level is low. You must replace them with new batteries to ensure proper functioning. 2HOWTO SET UPTHE URC By entering Device Code You may setup the URC by the following code entering instructions. 1.Refer to the DEVICE CODE LIST, look up the 4-digit Device Code which corresponds to the brands of your A/V equipment. If there are more than one Device Code listed under your brand, try from the first code. 2.Press a desired Device Mode Key (e.g. ).TV 3.Hold down “CH+ ” and “VOL– ”on the URC together simultaneously for 2 seconds until the indicator lights up. 4.Use the number keys to enter your 4-digit Device Code, the indi- cator should go out immediately. Turn on your device (e.g. TV), try the function keys on the URC. If your device (e.g. TV) responds to your invoked function correctly, you have entered the right Device Code. Otherwise, repeat the above setup instructions with the rest available Device Codes until your device (e.g. TV) responds to your in- voked function, and most keys work correctly. *Simply repeat the above procedures to enter the Device Codes for your VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key in step 2 above) Note : –DVD, CTV and other Device Codes can be entered into any device modes except “TV” & “VCR” modes. Just simply press the device mode key and enter your 4-digit device code for DVD, CTV and other devices. If the indicator flashes twice in step 4, a wrong DeviceCode has been entered. You are required to repeat step 2 to 4 again. Suggestion : –If you cannot find a correct Device Code for your equipment, see2 HOW TO SET UP THE URC– By Searching Through the Library. –You are recommended to jot down your Device Codes in the space provided on back label after setting up the URC correctly for future reference. 1By SearchingThrough the Library English If you cannot identify a correct Device Code for your equipment from the Device Code list, you may search the code through the library:- 1.Turn on your device manually (e.g. TV). 2.Press a desired Device Mode Key (e.g. ).TV 3.Hold down “CH+ ” and “VOL– ” on the URC together simultaneously for 2 seconds until the indicator lights up. 4.Enter a corresponding Magic Search Code from following table. The in- dicator should go out immediately. DEVICETYPE:TVVCRSATCTVDVD MAGIC SEARCH CODE:00010002000300040005 (e.g. press device mode key,then press “TV enter TV Magic Search Code 0001.) CH+ ” and “VOL– ” , and 5.Press the same desired device mode key again as in step 2 above. (e.g. )TV 6.Hold down “CH+ ” & “VOL– ” together simultaneously for 2 seconds until the indicator lights up, and your URC is ready to start searching. 7.Aim the URC at your device (e.g. TV), press the “ ” key repeatedly, slowly and patiently until the device has been turned off. Once your device has been turned off, immediately press Device Mode Key (e.g.)TV to lock in code and the indicator should go out. *Simply repeat the above setup procedures to search the Device Code for your VCR, SAT, DVD or... »