Notice PHILIPS SRU-5030

« e selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-9 Adding a function to the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Restoring the original remote control settings . . . . . . . . . . . . . . . . . . . . . 9 5.Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 6.Need help?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Code list of all brands / equipment . . . . . . . . . . . . . . . . . . . . . . . . . . 60-76 Information to the Consumer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78 1.Introduction Congratulations on your purchase of the Philips SRU 5030 universal remote control.After installing the remote control you can operate a maximum of 3 different devices with it:TV,DVD player/recorder and VCR. You can find information about how to prepare this remote control for use in the chapter ‘Installing the remote control’. 2.Installing the remote control Inserting the batteries1Press the cover inwards and slide it in the direction of the arrow.2Place two AAA type batteries into the battery compartment,as shown.3Slide the cover back and click it firmly into place. Note:If the mode keys (TV,DVD and VCR)blink four times after every key press,the remote control is indicating that its batteries are running low.Replace the old batteries with two new AAA batteries. Testing the remote control The remote control has been programmed to operate most Philips devices. Because the SRU 5030 may use different signals for each brand and even for different models of the same brand,it is advisable to test whether your device responds to the SRU 5030.The example below (TV) instructs you how to do this.You can repeat the same steps for other devices (DVD player/ recorder and VCR) which you want to operate using the SRU 5030. Example of TV:1Turn your TV on manually or use the original remote control. Tune to channel 1.2Press the TV key to select TV. Press the key until it lights up. –If the key does not light up,check whether the batteries are properly inserted (see ‘Inserting the batteries’). 4 Instructions for use EnglishInstructions for use English 5 3Check whether all the keys are working. For an overview of the keys and their functions see ‘3.Keys and functions’. –If the TV responds as it should to all of the key commands the SRU 5030 is ready for use. •If the device does not respond at all or not to all of the key commands,follow the instructions under ‘Setting the remote control’,or for online setup go to: www.philips.com/urc. Setting the remote control This is only necessary if your device does not respond to the SRU 5030. If that is the case,the SRU 5030 does not recognize the brand and/or model of your device and you need to program the remote control to do so. The example below (TV) instructs you how to do this.You can repeat the same steps for other devices (DVD player/recorder and VCR) which you want to operate using the SRU 5030. You can set the remote control either automatically or manually. Automatically setting the remote control The remote control will now automatically search for the right code for your device. Example of TV:1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The SRU 5030 emits the ‘swi... »