Notice PHILIPS SRU-1060

« ....................................................................................6-8 3.Keys and functions..........................................................................................9 4.Restoring the original functions of your remote control....................10 5.Troubleshooting.......................................................................................10-11 6.Need help?......................................................................................................11 Code list of all brands / equipment................................................................92-105 Information to the Consumer...................................................................................106 1.Introduction Congratulations on your purchase of the Philips SRU1060 universal remote control.After installing the remote control you can operate a TV and a DVD player/recorder with it. You can find information about how to prepare this remote control for use in the chapter ‘Installing the remote control’. 2.Installing the remote control •A battery is already placed in the battery compartment of the SRU1060.Just remove the protective foil from the battery and the SRU1060 is ready for use. Replacing the battery The SRU1060 comes with one spare battery in the packaging.1Press the little latch on the right hand side of the battery compartment Keep the latch pressed and slide the compartment outwards. 4ENGLISH SRU1060_A6.qxd6 25-08-2005 12:03 Pagina 42Place the spare CR2025 Lithium battery into the battery compartment,as shown. Make sure to place the text side of the battery upwards.3Slide the cover back and click it firmly into place. Note:If the LED blinks four times after every key press,the remote control is indicating that its battery is running low.Replace the old battery with a CR2025 Lithium battery. Testing the remote control The remote control has been programmed to operate most Philips brands. Because the SRU1060 may use different signals for each brand and even for different models of the same make,it is advisable to test whether your brand responds to the SRU1060. The example below (TV) instructs you how to do this. You can repeat the same steps for your DVD player/recorder which you want to operate using the SRU1060. Example of TV:1Turn your TV on manually or use the original remote control. Tune to channel 1.2Check whether all the keys are working. For an overview of the keys and their functions see ‘3.Keys and functions’. –If the TV responds as it should to all of the key commands the SRU1060 is ready for use. If the LED does not light up,check whether the battery has been properly inserted. See ‘Inserting the battery’. •If the device does not respond at all or not to all of the key commands,follow the instructions under ‘Setting the remote control’,or for online setup go to:www.philips.com/urc. 5ENGLISH SRU1060_A6.qxd6 25-08-2005 12:03 Pagina 5Setting the remote control This is only necessary if your brand does not respond to the SRU1060. If that is the case,the SRU1060 does not recognize the brand and/or model of your brand and you need to program the remote control to do so. The example below (TV) instructs you how to do this. You can repeat the same steps when setting the SRU1060 for your DVD player/recorder. You can set the remote control either automatically or manually. Automatically setting the remote control The remote control... »