Notice RUWIDO Linum

« , proceed as described for the CD PLAYER but using the key instead of the CD key. Please ensure that you refer to the codes listed under the TAPE section and not the CD PLAYER section. Easy programming for the control of your AMPLIFIER (not for 5 in 1 model) To programme the remote control to operate your AMPLIFIER, proceed as described for the CD PLAYER. Complete steps 1 to 10, using the key on your remote control. Please ensure that you refer to the codes listed under the AMPLIFIER section and not CD PLAYER section. Code scan If programming using the codes in the enclosed list failed to work then you must next try the automatic code scan. A.Ensure that the remote control is equipped with 2 new batteries (see step one of easy programming procedure). B.Switch on your TV SET. When using the automatic scan function for the VCR, DVD, CD or TAPE, switch on your device, insert a video tape, DVD, CD or tape cassette and put the unit into ‘Play mode’ i.e, the VCR tape etc is running. C.Press the key of your remote control for approx. 4 seconds until the LED flashes twice. D.After seeing the 2 flashes and within 5 seconds, enter the code . After entering the code the LED will flash twice indicating that the code has been accepted E.Press and hold the key until your TV switches off. Please note that this process might take up to 15 minutes. During the automatic scanning you can remove your finger or change hands provided it is replaced within 8 seconds. If left off of the key for more than 8 seconds then the remote will revert back to its normal mode. If your TV switches into Stand-By mode during the automatic process then immediately remove your finger from the key and then press the key until the LED flashes twice, this will then store the code that the remote control has found. F.In some cases during the automatic scanning search the remote control might find several codes that appear to operate your TV etc, however, if some of the buttons fail to work properly then it’s possible the remote has found a partially compatible code. In such cases you will need to restart the automatic scanning process (steps B. to F.) until a better code is found. Please note that once the automatic process is restarted, the remote continues from the last stored code and not at the beginning of code database. • To complete a code scan for the VCR, DVD, CD or TAPE, follow the procedure above but use the key and not the key • To complete a code scan for the TUNER, follow the procedure above but use the key 2 TV 100 TV AMP TAPE TUNER CD SHIFT 3 UNIVERSAL REMOTE CONTROL Thank you for purchasing this universal remote control. Before using the remote you will need to insert two type "CR2025" batteries (for all Linum models) or two AAA "LR03" batteries (for AlveusLux 10 and 5 in 1 models) in the battery compartment ensuring that you follow the polarity shown on the inside. You can now use your remote control to operate up to 10 different devices including a TV, video recorder, DVD player, satellite or cable receiver, CD player, tuner (radio), tape recorder and amplifier. If your remote control is equipped with an AUX key then you can also use it to control a second TV set, video recorded, satellite receiver and/or cable box, CD player, tuner, tape recorder or amplifier! Easy programming for the control of your TV SET 1.Insert 2 new batteries of type "CR2025" or "AAA/LR03" (depending on your model). Observe batter... »