Notice BLACK & DECKER CV7205

« al may present a risk of personal injury.
Retain this manual for future reference. Using your appliance
Do not use the appliance to pick up liquids or any materials that could catch fire.
Do not use the appliance near water. Do not immerse the appliance in water.
Never pull the charger lead to disconnect the charger from the socket. Keep the charger lead away from heat, oil and sharp edges. After use
Unplug the charger before cleaning the charger or charging base.
When not in use, the appliance should be stored in a dry place. Children should not have access to stored appliances. Inspection and repairs
Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.
Do not use the appliance if any part is damaged or defective.
Have any damaged or defective parts repaired or replaced by an authorised repair agent.
Regularly check the charger lead for damage. Replace the charger if the lead is damaged or defective.
Never attempt to remove or replace any parts other than those specified in this manual. Battery and charger
Never attempt to open the battery.
Do not expose the battery to water.
Do not incinerate the battery.
Do not expose the charger to water.
Do not open the charger. Electrical safety Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug. Symbols on the charger Your charger is double insulated; therefore no earth wire is required. Fail safe isolating transformer. The mains supply is electrically separated from the transformer output. The charger automatically shuts off if the ambient temperature becomes too high. As a consequence the charger will be inoperable. The unit must be disconnected from the mains supply and taken to an authorised service centre for repair. The charger is intended for indoor use only. Features 1.On/off switch 1.Two-speed on/off switch (CV1205)6 ENGLISH 2.Release button 3.Dust bowl 4.Charging base 5.Filter cleaning wheel (CV9605/CV1205) 6.Charging indicator Fig. A 7.Crevice tool 8.Brush tool Installation Fitting the charging base to the wall (fig. B) The charging base can be placed on a worktop or fitted to the wall to provide a convenient storage and charging point for the appliance. Assembly Fitting the accessories (fig. A & C) These models are supplied with the following accessories: -a crevice tool (7) for confined spaces -a brush tool (8) for furniture and stairs To fit an accessory, proceed as follows:
Take the accessories from the appliance.
Insert the appropriate accessory into the front of the appliance. Use
Before first use, the battery must be charged for at least 16 hours.
Place the appliance on the charging base whenever it is not in use. Charging the battery (fig. B)
Make sure that the appliance is switched off. The battery will not be charged with the on/off switch in the on position.
Place the appliance on the charging base as shown.
Plug in the charger. Switch on at the mains. The charging indicator (6) will be lit.
Leave the appliance to charge for at least 16 hours. Whilst charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connect... »