Notice PHILIPS FC9016/01 Universe 2

« e and turn it clockwise.(fig.1) 2To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance. Tube Conical coupling (specific types only) ?To connect the tubes to the handgrip,insert the narrow section into the wider section while turning it.(fig.2) Use the same method to connect the accessories to the tube. To disconnect,turn the tube or the accessories anticlockwise and pull. Button coupling (specific types only) ?Connect the tube to the handgrip ("click").(fig.3) Use the same method to connect the accessories to the tube. ?To disconnect the tube from the handgrip, push the lock button and pull the tube out of the handgrip.The accessories are disconnected in the same way. Telescopic tube (specific types only) 1Connect the tube to the handgrip ("click"). 2Adjust the tube to the length you find most comfortable during vacuum cleaning.(fig.4) Convertible nozzle (specific types only) The convertible nozzle can be used on either carpets or hard floors. 1Connect the convertible nozzle to the telescopic tube ("click"). 2Push the rocker switch on top of the convertible nozzle with your foot to make the brush strip for cleaning hard floors come out of the nozzle housing.(fig.5) 3Push the rocker switch again to make brush strip disappear into the convertible nozzle housing again.(fig.6) Reach & Clean nozzle (specific types only) ?The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be turned 360 degrees to 4 different positions,allowing you to also vacuum clean hard-to-reach places in an easy way.When the nozzle is positioned lengthwise,the suction power is concentrated at the front side of the nozzle.(fig.7) ?To adjust the nozzle to the type of floor and the area to be cleaned,put your foot on the indicated spot and then turn the tube until the nozzle is in the required position.(fig.8) 1With the nozzle positioned breadthwise and the brush strip folded out,you can clean large hard floor areas.Turn the nozzle until the brush strip pops out of the nozzle housing and the nozzle is positioned breadthwise.(fig.9) 2With the nozzle positioned lengthwise and the brush strip folded out,you can vacuum clean small hard floor areas.Turn the tube 90 degrees anti-clockwise until it is positioned lengthwise with the brush strip still folded out of the nozzle housing.(fig.10) 3With the nozzle positioned breadthwise and the brush strip folded in,you can vacuum clean large soft floor areas.Turn the tube 90 degrees anti-clockwise again to position the nozzle breadthwise and to make the brush ENGLISH 6strip disappear into the nozzle housing.(fig.11) 4With the nozzle positioned lengthwise and the brush strip folded in,you can vacuum clean small soft floor areas.Turn the tube 90 degrees anti-clockwise again until it is positioned lengthwise with the brush strip still folded in.(fig.12) Crevice tool and small nozzle 1Connect the crevice tool (1) or small nozzle (2) directly to the handgrip or to the tube.(fig.13) Accessory holder 1The accessory holder can simply be snapped onto the handgrip.(fig.14) ?The crevice tool and the small nozzle can be stored in the accessory holder by pushing them in the holder.(fig.15) Please note the way in which the small nozzle must be placed in the accessory holder. Vacuum cleaning Adjusting suction power ?You can adjust the suction power while vacuum cleaning 1Adjust the suc... »