Notice PHILIPS HR1851

« sponds to the local mains voltage before you connect the appliance. -Do not use the appliance if the plug, the mains cord or other components are damaged. -If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly quali?ed persons in order to avoid a hazard. -This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -Children should be supervised to ensure that they do not play with the appliance. -Never let the appliance operate unattended. -Always check the ?lter before use. If you detect any cracks or damage, do not use the appliance. Contact the nearest Philips service centre or take the appliance to your dealer. -Never reach into the feeding tube with your ?ngers or an object while the appliance is running. Only use the pusher for this purpose. -Do not touch the small blades in the base of the ?lter. The blades are very sharp. Caution -This appliance is intended for household use only. -Never use any accessories or parts from other manufacturers or that Philips does not speci?cally recommend. If you use such accessories or parts, your guarantee becomes invalid. -Make sure all parts are correctly mounted before you switch on the appliance. -Only use the appliance when both clamps are locked. -Only unlock the clamps after you have switched off the appliance and the ?lter has stopped rotating. ENGLISH -Do not remove the pulp container when the appliance is operating. -Always unplug the appliance after use. Electromagnetic ?elds This Philips appliance complies with all standards regarding electromagnetic ?elds (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scienti?c evidence available today. Preparing for use 1 Clean all detachable parts (see chapter ‘Cleaning’). 2 Pull the mains cord out of the cord storage compartment at the back of the appliance. 3 To attach the spout to the juice collector, snap it into position (Fig. 2). 4 Place the juice collector onto the appliance and put the ?lter in the juice collector. Make sure the ?lter is ?tted securely onto the driving shaft (Fig. 3). Always check the ?lter before use. If you detect any cracks or damage, do not use the appliance and contact the nearest Philips service centre or take the appliance to your dealer. 5 To attach the pulp container to the appliance, align the latch on the pulp container with the slot on the motor unit and then push the pulp container home. Hold the lid over the ?lter and lower it into position. (Fig. 4) You can also empty the pulp container while you are preparing juice. Switch off the appliance, remove the pulp container carefully and empty it. Note: Reassemble the empty pulp container before you continue juicing. 6 Snap the two clamps onto the lid to lock it into place (‘click’). Slide the pusher into the feeding tube. (Fig. 5) Make sure the clamps are locked into position on either side of the lid. 7 Place the juice jug under the spout (Fig. 6). The juice jug has a removable foam separator to separate the foam from the juice when you pour the juice into a glass. Using the appliance Note: Only sw... »