Notice AXIS 221

« al connector 3-pin connector block for connecting power to the 3-pin power connector CDAXIS Network Video Product CD, including product documentation, installation tools and other software Printed MaterialsAXIS 221/223M Installation Guide (this document) Axis Warranty Document To use the AXIS 221/223M outdoors it must be installed in a protective housing. For more information on protective housings and other accessories, please visit www.axis.com Important! This product must be used in compliance with local laws and regulations.Page 4AXIS 221/223M Installation Guide Hardware overview Dimensions HxWxD = 49 x 88 x 200mm (1.9" x 3.5" x 7.9") Weight = 620g (21.9oz) (power supply not included) Status indicator Zoom puller (Tele/wide) Focus puller DC-Iris PS-K power adapter connector 10-pin I/O terminalPower indicator Network indicator Reset/Control button connector RS-232 connector DC-Iris control cable DC-Iris control cable PS-K connector RS-232 connector Network (also PoE) connector Power and network indicators Reset/Control button Audio out Audio in connector 10-pin I/O AXIS 223M - Rear view AXIS 221 - Rear view AXIS 221/223M Front view Power connector block terminal Product ID & Serial number (S/N). The serial number may be required during the installation. Network (also PoE) connector Network (also PoE) connector power adapter connector Power blockAXIS 221/223M Installation GuidePage 5 ENGLISH ENGLISH ENGLISH Connect the cables 1.Connect the camera to the network using a shielded network cable. 2.Optionally connect external input/output devices, such as alarm devices. See page13 for information on the terminal connector pins. 3.Optionally connect an active speaker and/or external microphone (AXIS 223M only). 4.Connect power, using one of the methods listed below: •PoE (Power over Ethernet). If available, this is automatically detected when the network cable is connected (see above). •Connect the supplied indoor power adapter* to the power connector on the camera. •The 3 pin power connector block on the rear panel. See the illustration below. 5.Check that the LED indicators show the correct conditions. See the table below for further details. Note that some LEDs can be disabled and may be unlit. 3 pin power connector block LED indicators * only use the supplied PS-K power adapter LEDColorDescription NetworkGreenSteady for connection to 100 Mbit/s network. Flashes for network activity. AmberSteady for connection to 10 Mbit/s network. Flashes for network activity. UnlitNo connection. StatusGreenShows steady green for normal operation. Note: The Status LED can be configured to be unlit during normal operation, or to flash only when the camera is accessed. See the online help files for more information. Go to Setup > System Options > LED settings AmberSteady during startup, reset to factory default or when restoring settings. RedSlow flash for failed upgrade. PowerGreenNormal operation. AmberFlashes green/amber during firmware upgrade. GNDDC+Connect DC power (7-24V) on pins 1 and 2. Connect AC power (10-24V) on pins 2 and 3. AC AC 123Page 6AXIS 221/223M Installation Guide Assign an IP address To make it accessible on the network, the AXIS 221/223M must be assigned an IP address. Depending on the number of cameras you wish to install, the recommended method for assigning IP addresses in Windows is eithe... »