Notice D-LINK DKT-810

« ntact your reseller. Default IP: 192.168.1.1 Default Username: admin Default Password: admin 1 Remove the D-Link Click and Connect CD.2 A. Be sure your Internet connection is active. DO NOT plug the router in yet. B. Insert the D-Link Click’n Connect CD into your computer. C. ClickQuick Installation Package Contents DKT-810ALL-IN-ONE ADSL2+ STARTER KIT RJ-11 cable23 • The default username is ‘admin’. The default password is also ‘admin’. • If you have changed the password and can not remember it, you will need to reset the router to the factory default setting (steps in question 2), which will set the password back to ‘admin’. 2. How do I reset my router to factory default settings? • Ensure the router is powered on. • Press and hold the reset button on the rear of the device for 20 seconds. Note: Resetting the router to factory default will erase the current configuration settings. To re- configure your settings, log into the router as outlined in question 1, then run the Setup Wizard. 3. How do I add a new wireless client or PC if I have forgotten my Wireless Network Name (SSID) or Wireless Encryption Key? • For every PC that needs to connect to the router wirelessly, you will need to ensure you use the same Wireless Network Name (SSID) and encryption key as the DSL router has. • Use the web based user interface (as described in question 1 above) to check or choose your wireless settings. • Make sure you take a note of the settings so that you can enter them into each wirelessly connected PC. D-Link has provided a handy sticker for you to note them down and attach to your router, or other location you find most convenient. 4. What can I do if my router is not working correctly? • The manual contains a full troubleshooting section and can be downloaded from the D-Link website (see below), however there are a few quick steps you can take to try and resolve any issues: • Check the LED’s on the front of the router. The Power, WLAN, DSL and Internet LED should be on. One or more of the LAN LED should flash. • Check that all the cables are firmly connected at both ends. • Power the router off for 20 seconds, and then power it back on. 5. What can I do if I can’t get a wireless connection with my laptop or PC? • Try running the wireless in the same room first with line of sight to the DSL-2740B router. • Check all your wireless cards are enabled on the laptop and PCs you wish to use. If your laptop has built-in wireless, please check it is enabled as it may require a particular switch or key-press to enable the wireless function. 6. Why can I not get an Internet Connection? • For ADSL ISP users please contact your ISP to make sure the service has been enabled/ connected by your ISP and that your ISP username and password are correct. Technical Support Thank you for choosing D-Link products. For further information, support, product updates or to download the User Manual please visit the D-Link website at www.dlink.eu. http://www.dlink.co.uk4 Important Information Important information regarding your internet subscription Users who subscribe to limited or “pay as you use” broadband internet access. In the WAN con?guration settings, there is a parameter called Maximum idle timer. This parameter controls how many seconds of inactivity before dropping connection to the internet. The default setting is “0” which disables this functionality and the internet will be... »