Notice ALPATEC BY TAURUS DH12ML disponible gratuitement après inscription

Extrait de la notice

back to its position. 15 12 33 bis notice DH_12 ML:notice DH_25EC 21/12/07 11:37 Page 15OPERATION INTRUCTION 1.Put the humidity control switch on ARRÊT position. 2.Install permanent drainage (if needed). 3.Plug the product. 4.Turn the humidity control switch clockwise. The humidity rate can be adjusted from 20 to 80%, the middle position is for 60%. Operation LED are blue. MAX position means that the product will keep on dehumidifying. 5.When the water tank is full, the product stops working. Operation LED are red colour. 6.Remove the tank, empty and replace it. The product starts again. If the product does not restart, control the tank position. 7.To stop the product, turn the humidity control switch in ARRÊT position. When the product is stopped, wait for 3 minutes before restarting it (compressor protection). NOTE: for a better dehumidifying effect, keep clear the areas in front and rear of the product. 16 notice DH_12 ML:notice DH_25EC 21/12/07 11:37 Page 16MAINTENANCE Stop and unplug the product before any operation. Use a soft and dry cloth to clean the body Never use detergent, chemical product or cleansing solution. Filter is located behind air inlet 2. Remove the water tank and extract the filter: Fig 4. Use a vacuum cleaner or tap it smoothly. If it is very dirty use warm water with soap, rinse and dry. Replace the filter. Check the filter regularly. When you do not use the appliance for a long time: -Stop it -Unplug it -Empty and dry the water tank -Cover and store the product away from the sunlight 17 4 notice DH_12 ML:notice DH_25EC 21/12/07 11:37 Page 17TROUBLE SHOOTING Before asking for repair service, please check the following points: PROBLEMPOSSIBLE CAUSESOLUTION If you have not solved the problem, stop...