Notice ALTEC LANSING VS3151 disponible gratuitement après inscription

Extrait de la notice

pushing the On/Off button located on the control pod . An LED will light on the control pod when the power is ON. Note: To avoid hearing a popping sound when you turn on your Altec Lansing speaker system, always turn on your audio source first. Master Volume The VOLUME knob on the control pod controls the master volume. Turn the knob clockwise to increase the volume and counterclockwise to decrease the volume. Six-Piece Powered Audio SystemVS31513 Sound Pressure Level (SPL):103 dB Total Continuous Power:50 Watts RMS • Front Speakers:5 Watts/channel @ 8 ohms @ 10% THD @ 150 Hz – 20 kHz 2 Channels Loaded • Rear Speakers:5 Watts/channel @ 8 ohms @ 10% THD @ 150 Hz – 20 kHz 2 Channels Loaded • Center Speaker:10 Watts @ 8 ohms @ 10% THD @ 150 Hz – 20 kHz Single Channel Loaded • Subwoofer:20 Watts @ 8 ohms @ 10% THD @ 40 – 150 Hz Single Channel Loaded System Response:40 Hz – 20 kHz (-10 dB) Signal to Noise Ratio @ 1 kHz input:> 80 dB Drivers (per satellite):One 2" full-range driver Subwoofer: One 5.25" woofer POWER REQUIREMENTS USA, Canada and applicable Latin American countries:120 V AC @ 60 Hz Europe, United Kingdom, applicable Asian countries, Argentina, Chile and Uruguay:230 V AC @ 50 Hz ETL/cETL/CE/NOM Approved System Specifications* No LEDs are lit.Power isn’t turned on. AC power cord isn’t connected to the wall outlet. Surge protector (if used) isn’t powered on. Wall outlet not functioning. Turn on the speaker system by pushing the On/Off button located on the control pod. An LED will light on the control pod when the power is ON. Check to see if the “Power On” LED is illuminated on the control pod. If not, connect AC power. If the AC power cord is plugged into a surge protector, make sure the surge prot...