Notice BIOSTAR P4M890-M7 TE disponible gratuitement après inscription

Extrait de la notice

in Assignment 1 Ground 2 +12V 13 3 FAN RPM rate sense Note: The JSFAN1 supports 3-pin head connector and the JCFAN1 supports 4-pin head connector. When connecting with wires onto connectors, please note that the red wire is the positive and should be connected to pin#2, and the black wire is Ground and should be connected to GND. Motherboard Manual 10 2.3 INSTALLING SYSTEM MEMORY A. Memory Modules DIMM1 DIMM2 1. Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot. 2. Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated. B. Memory Capacity DIMM Socket Location DDR Module Total Memory Size DIMM1 256MB/512MB/1GB/2GB DIMM2 256MB/512MB/1GB/2GB Max is 4GB. P4M900-M7 SE/P4M890-M7 TE 11 2.4 CONNECTORS AND SLOTS FDD1: Floppy Disk Connector The motherboard provides a standard floppy disk connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon cable. 34 331 2 IDE1/IDE2: Hard Disk Connectors The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 functionality. It has two HDD connectors: IDE1 (primary) and IDE2 (secondary). The IDE connectors can connect a master and a slave drive, so you can connect up to four hard disk drives. The first hard drive should always be connected to IDE1. IDE2IDE1 21 3940 Motherboard Manual 12 PCI-EX16: PCI-Express x16 Slot - PCI-Express 1.0a compliant. - Maximum theoretical realized bandwidth of 4GB/s simul...