will prevent motor overloads and the con- sequences of all types that could otherwise result, consequences for which we decline all responsability. 2. INSTALLATION The installation of these electric pumps is only permitted in swimming pools or ponds that comply with standards IEC 60364-7-702 and/or the national regulations of the country in witch the product is to be installed The pump must be installed in horizontally, at least two metres from the wall of the pool, and at the same height as the level of the water, or if possible, below. It is not advisable to install the pump at more than 3 m geometrical height from water level. Independently of the geometrical height and the power of the model chosen, self-priming times may be up to 10 min. The pump must be fixed on a firm base, with screws of 6 or 8 mm dia- meter, through the prepared holes in the foot. The pump should be protected from possible flooding and receive dry ventilation. 3.INSTALLING THE LINES The supports of the suction and discharge lines will be independent of those of the pump. In the case of plastic lines, ensure tightness of joints and threads with TEFLON tape alone.Glue or similar products should not be used. The suction line should have a diameter equal to or greater than that of the suction mouth of the pump. The inside of the suction and discharge holes is threaded to a certain depth. This depth should not be exceeded when screwing on the respective lines. Only new or clean connectors should be used. The suction lines should be structured with a slight slant to prevent the for- mation of siphons. 4. ELECTRICAL CONNECTION The electrical installation should have a multiple separation system with contact opening of a least 3 mm. The pump should have a power suppl...