Notice NAD C315BEE disponible gratuitement après inscription

Extrait de la notice

d home. For best performance, use quality speaker leads of 16 gauge (1.5mm) thickness or more. If the unit is not going to be used for some time, disconnect the plug from the AC socket. Should water get into your NAD C315BEE, shut off the power to the unit and remove the plug from the AC socket. Have the unit inspected by a qualified service technician before attempting to use it again. DO NOT REMOVE THE COVER, THERE ARE NO USER-SERVICEABLE PARTS INSIDE. Use a dry soft cloth to clean the unit. If necessary, lightly dampen the cloth with soapy water. Do not use solutions containing benzol or other volatile agents. QUICK START 1 Connect the speakers to the rear Speaker terminals and sources to the relevant rear input sockets. 2 Plug in the AC power cord. 3 Switch to ON, the POWER button on the rear panel, to turn the C315BEE to standby. 4 Press the front panel Standby button to turn the NAD C315BEE on. 5 Press the required input selector. FRONT PANEL CONTROLS (FIGURE 1) 1. Standby Button : The Standby Button turns on and to standby the C315BEE. This button will only function when the Power/Standby/ Protection LED is either amber representing the standby state, or green representing the on-state. 2 Power/Standby/Protection LED : Upon switching the power on, the LED will light up red for a few seconds before the protection circuit is deactivated. The LED will then turn green, representing normal operation. In cases of serious abuse of the amplifier, such as overheating, excessively low loudspeaker impedance, short circuit etc. the amplifier will engage its Protection circuitry, indicated by the LED turning from green to red, and the sound being muted. In such a case, turn the amplifier off by the rear panel POWER switch, wait...