Notice PIONEER CU-RF100U

Notice PIONEER CU-RF100U disponible gratuitement après inscription

Accédez à la notice du PIONEER CU-RF100U en adhérant à la communauté.

Notice d’utilisation de votre PIONEER CU-RF100U. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre CU-RF100U.

Notices - manuels - modes d'emploi disponibles pour PIONEER CU-RF100U après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

rol on page10. Note •You can cancel or exit any of the steps by press and hold MULTI OPERATION for a couple of seconds. To go back a step, press RETURN. Pairing the RF adapter and remote control Pairing is necessary in order to use the RF communications function. Perform the operation below after connecting the RF adapter and receiver. 1Switch on the receiver. 2Setting the ‘RF Remote Setup’ or ‘EXTENSION Setup’ to ‘ON’ for the receiver’s ‘Other Setup’. For details, see receiver’s operating instructions. 3Press the SETTING button on the front of the RF adapter. RF adapter’s LED blinks red. 4While pressing MULTI OPERATION, press VIDEO PARAMETER on the remote control. The remote display shows PAIRING. 5Press ENTER on the remote control. AUTHORIZATION flashes and pairing is performed. When pairing is successful, SUCCESS is displayed and pairing is completed. RF adapter’s LED lights green. The display on the receiver itself is displayed on the remote control’s display. For details, see Remote control display on page24. If ERROR is displayed, pairing has not been successful. Check the connections and distance with the RF adapter, then start over from step 1. The remote control unit’s receiver operation mode must be set to “RF” in order to operate the receiver with RF two-way communications. Make this setting as described at Operating the receiver by RF communications on page7. CU-RF100.book Page 6 Wednesday, March 17, 2010 6:13 PMUsing the RF communications function02 7 En EnglishOperating the receiver by RF communications Use this procedure to make the remote control settings to operate the receiver using RF two- way communications. The settings can be made individually for the main zone, ZONE...

En cours...