es to the amplifier using the supplied speaker input connector. •Do not connect both the RCA input and the speaker input at the same time. 7Connections when using the speaker input 10mm Twist Speaker wire Lug Speaker output terminal Terminal screw Speaker wire Speaker output Car Stereo Speaker input connector To speaker input terminal of this unit. White: Left + Gray: Right + White/black: Left ? Gray/black: Right ?9 Connecting the Unit Connecting the Speaker wires The speaker output mode can be two-channel (stereo) or one-channel (mono). Connect the speaker leads to suit the mode according to the fig- ures shown below. •Do not connect both the RCA input and the speaker input at the same time. Two-channel mode (stereo) One-channel mode (mono) (Left) Speaker (Right) Speaker (Mono)Installation 10 ENGLISHESPAÑOLDEUTSCHFRANÇAIS ITALIANONEDERLANDS CAUTION •Do not install in: —Places where it could injure the driver or pas- sengers if the vehicle stops suddenly. —Places where it may interfere with the driver, such as on the floor in front of the driver’s seat. •Make sure that wires are not caught in the sliding mechanism of the seats, resulting in a short-cir- cuit. •Confirm that no parts are behind the panel when drilling a hole for installation of the amplifier. Protect all cables and important equipment such as fuel lines, brake lines and electrical wiring from damage. •Install tapping screws in such a way that the screw tip does not touch any wire. This is impor- tant to prevent wires from being cut by vibration of the car, which can result in fire. •DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. A...