Notice ROTEL RCD-06 disponible gratuitement après inscription

Extrait de la notice

e “out” position. NOTE: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the “on” position. When AC power is applied to the unit, it will power up in fully active mode. Output Connections The RCD-06 gives you a choice of two different kinds of output connections — an analog output signal from the built-in D/A converter for use with conventional analog audio components and a coax digital output which provides an unprocessed digital data signal for use with outboard D/A converters or digital processors. NOTE: To prevent loud noises that neither you nor your speakers will appreciate, make sure the CD player is turned off when you make any signal connections. Analog Outputs -- [See Figure 3 for wiring illustration] A pair of standard RCA jacks supplies an analog output signal from the RCD-06 to the source inputs of an audio preampli? er, in- tegrated ampli? er, or receiver. Select high quality audio interconnect cables. Connect the left channel output of the RCD-06 to the left channel source input on the preampli? er or other component. Connect the right output of the RCD-06 to the right channel source input on the preampli? er or other component. Digital Output == [See Figure 4 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-06, taken before the built-in D/A converter. This signal is supplied by the RCD-06’s back- panel digital output jack. Using a standard 75 ohm coax digital cable, connect the RCD-06’s coax digital output to the coax digital input connector on the outboard D/A converter. Operation The RCD-06 can be operated using its f...