Notice SMEG KSED61X-1

Notice SMEG KSED61X-1 disponible gratuitement après inscription

Accédez à la notice du SMEG KSED61X-1 en adhérant à la communauté.

Notice d’utilisation de votre SMEG KSED61X-1. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre KSED61X-1.

Notices - manuels - modes d'emploi disponibles pour SMEG KSED61X-1 après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

nstalled centrally over a cooking appliance. The minimum distance between the cooking surface and the metal grease filters on the underside of the hood must be at least 650mm. To install the hood proceed as follows: 1) Drill six 8mm diameter holes at X1-X2-J and insert the plastic rawl plugs supplied as illus- trated in fig. 2 ensuring the brackets are fitted as shown in the blow up. 2) Secure the two brackets C to the wall inserting two of the screws supplied through the two holes on line X1-X2 as illustrated in fig. 2. 3) Slide the canopy down the wall to locate the key hole over the washer then secure the can- opy to the wall by inserting two of the screws supplied through the two outer holes in the rim of the canopy J1 and J2 as illustrated in fig. 3. 4) EXTRACTION OR RECIRCULATION INSTALLATION: • EXTRACTION (DUCTED) When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. • To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. • Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove any activated charcoal filters. • RECIRCULATION (FILTERED) • When the hood is fitted in the recirculation mode the Air Outlet Connection H should be fitted as illustrated in fig. 6. • Fit the (optional) charcoal filters by repeating the following operation on each side of the motor housing. Place the two key hole slots in the filter L and turn the filter clockwise to lock the filter in position as illustrated in fig. 7. WARNING: It is a possible fire hazard if the metal grease filters are not cleaned and the charcoal filters replaced regularly....

En cours...