adapter (1) •AC power adapter (1) •AC power cable(s) –For NV-U70TW/U70TC*2 (2) –For NV-U50TG/U50G*2 (1) –For NV-U50F/U50D/U50I/U50A/U50B/U50S/ U50N/U50TD/U50TI/U50TB*2 (1) •USB cable (1) •TMC antenna (aerial) (1)/suction cups (2) (For NV-U70T/U50T) •Adhesive tape (1) •Pad (1) •Carrying pouch (1) •Application Disc (CD-ROM) (1) (For NV-U50T/U50) •Application Disc (DVD-ROM) (1) (For NV-U70T) •Quick Start Guide (1) •Warranty card (1) •User registration card (1) •END-USER LICENSE AGREEMENT (1) *1NV-U70T/U50T have a TMC aerial jack on the left side. *2The model names are written on the label on the bottom of the main unit.7 Installing the unit About the main power switch Before installation, switch on the main power by sliding the POWER switch to the ON position. Thereafter, you can turn the unit on/off by pressing ?/1 on the top right of the unit. Notes •Keep main power on unless the unit is not to be used for more than 3 months. •If you switch off the main power, it may take time to receive GPS signals when switching on again. About the suction mount Before you start, choose a position on the windscreen that is clearly visible to the driver without obstructing the road view, and make sure all surfaces are clean and dry. The optional cradles NVA-CU3T/CU3 can also be installed following the steps below. Notes •Install the unit in a safe place where it does not interrupt the GPS signal. •Detach and reattach the cradle regularly as cup suction is affected by high/low temperature, extended use, etc. •Be sure to keep a distance between the cradle and dashboard when installing. 1Attach the cradle on the windscreen. Figure example of completed cradle installation Follow steps 1 - 3 to complete. 1Clean and dry...