Notice SONY VPL-HS20 disponible gratuitement après inscription

Extrait de la notice

e weight of the projector. 6Fasten the end of the safety wire of the Conversion Lens to the bottom of the projector using the screw supplied with the Conversion Lens (M5×8, with washer). Note Be sure to fasten the end of the safety wire of the Lens to the bottom of the projector. When installing the projector on the ceiling Be sure to fasten the end of the safety wire of the Lens to both the projector and the PSS-610 Projector Suspension Support in step 6, as illustrated below. In this case, use the screw (M5×12, with washer) supplied with the PSS-610. First, place the PSS-610 ( 1 ) on the projector, then place the safety wire ( 2 ) on the PSS-610. WARNING Be sure to use the screw (M5×12 with washer) supplied with the PSS-610. Never use the screw supplied with the Conversion Lens. If you use the screw supplied with the Lens, the Lens may fall from the projector and may cause injury. Notes on installation of the optional Conversion Lens •The Lens scratches easily, so when handling it, always place it gently on a stable and level surface in a horizontal position. •Be sure not to bump the Lens on the surface of the lens of the projector. •Avoid touching the Lens surface. To remove the installed Conversion Lens 1Remove the end of the safety wire of the installed Lens from the bottom of the projector by removing the screw. 2Turn the installed Lens counterclockwise until it can be removed. Notes •Be sure not to drop the uninstalled Conversion Lens. •When you adjust picture distortion using “V Keystone” or “Side Shot” in the INSTALL SETTING menu with the optional Conversion Lens attached to the projector, the aspect ratio of the original picture may not be correctly displayed. Installing the Projector and a Screen —...