Notice THOMSON ROC 8507 disponible gratuitement après inscription

Extrait de la notice

(1-2 seconds). 11. As soon as the device to be controlled turns off , press OK to store the code. 12. The display briefl y indicates SUCCESS before exiting the programming mode. Note 1: Each time the (?) key is pressed, the remote control sends a signal to the device. This signal corresponds to a code in the code library stored in the remote control memory. If you go past the required code, use the PROG - key to go back (or advance using PROG +) inside the code library. Note 2: The indication SEARCHING FOR remains on display during this mode. Testing the remote control before programming 1. Turn on the device that you wish to control. 2. Press the key that corresponds to the type of device to be controlled: TV: TV set, DVD: DVD player/recorder, VCR: video cassette recorder, STB: satellite, cable, ADSL, DVBT: DTT adaptor, AMP: amplifi er AUDIO: Hi-Fi system, AUX: device of your choice (e.g., second TV set or DVD player, etc.), 3. Point the remote control at the device to be controlled and try to turn it off using the ? key. If the device does not go off , you should program the remote control following one of the procedures A, B, C or D described below. Identifying a code: Press and hold a mode key. The code stored in memory for this mode is displayed (e.g., DVD…..0768). Note: Except for the TV key, every mode key (DVD, VCR, etc.) can be programmed to control a device other than the one indicated on the key. It is thus possible to assign, for example, the DVD mode to the VCR key. You should enter the code that corresponds to the desired brand and device following one of the procedures indicated in this manual.4 GB System setup Using the SETUP keys (hold down for 7 seconds), and...