Notice TOPCOM Wireless Webr@cer 8001 A/B

« with the essential requirements of the R&TTE directive. NLHet toestel voldoet aan de basiseisen van de R&TTE-richtlijn. Dit wordt bevestigd door de CE-markering. FRLa conformité de l’appareil avec les exigences fondamentales de la directive européenne R&TTE relative aux terminaux, est confirmée par le label CE. ESEl sello CE corrobora la conformidad del equipo con los requerimientos básicos de la directiva R&TTE. PTO símbolo CE indica que esta unidade cumpre com os requisitos essenciais da directiva R&TTE. PLSymbol CE oznacza, e urzdzenie spenia istotne wymogi dyrektywy R&TTE. For use in all EU countries, Switzerland, Norway, Turkey and Russia. For France, the output power is restricted if used outdoor and in the range 2454-2483,5 Mhz. For Italy, depending on the usage, a general authorization may be required.English 1 Installing your ADSL router. To install your router you will need to go through the following 4 steps: Step 1: Hardware installation Step 2 : Setting up the ADSL connection Step 3: Checking the connection status Step 4 : Setting the Wireless LAN part Before you begin. •Please make sure you have subscribed to an ADSL service. This means that your telephone line needs to be activated for ADSL. •Together with this subscription, your Internet provider should have provided you with the connection settings for the ADSL line. •Please make sure you have the following information at hand during the installation: -VPI : value from 0 to 255 -VCI : value from 1 to 65535 -Encapsulation type : LLC or VCMUX -Connection type : Fixed IP, DHCP Client or PPPoA / PPPoE. In case of PPPoA or PPPoE you should have received a connection username and password. In case of Fixed IP, you should have received an IP-address, Subnet mask and a Gateway number as well as DNS-server addresses. •Make sure that you have installed the ADSL splitter or filter to separate your telephone line from the ADSL line.2 Step 1: Hardware installation 1Step 1: Hardware installation Please connect your ADSL router according to the diagram below. Remark: The filter/splitter type will be different for each country. Please make sure you are using the correct type. •POWER : Connect the power adapter to the ADSL router and plug it into the wall socket. The power LED on the front panel will be lit when the power adapter is connected. •Antenna : Please screw the provided antenna to the reverse SMA connector. •ADSL : The WAN port is to connect your ASDL line. The link LED on the front panel will indicate that the ADSL line is connected. •Ports 1- 4 : Here you may connect up to 4 computers or other network devices. Connect your computer with the Ethernet cable for setting up the ADSL router. The LAN LEDs will indicate the connection status. •Reset Button : To load default settings, press the reset button and hold it for 10 seconds. It will load the factory default settings for the device. Do not press the reset button unless you want to clear the current settings. 2Step 2 : Setting up the ADSL connection It is strongly recommended that you go through this setup connecting your computer to the ADSL router with a cable. Please connect your computer to one of the Ethernet ports of the ADSL router by use of the provided Ethernet cable. Open the Internet browser and type http://192.168.1.1 in the URL Address bar. ... »