Notice ZYXEL ZyWall 2

« the following sections. 1 Hardware Connections You need the following. 1Hardware Connections 2Accessing the Web Configurator 3Bridge Mode 4Internet Access Setup and Product Registration 5DMZ 6NAT 7Firewall 8VPN Rule Setup 9Troubleshooting ZyWALLComputerEthernet Cables Power Adaptor ENGLISHENGLISH 2 Do the following to make hardware connections for initial setup. 1Use an Ethernet cable to connect the LAN/DMZ port to a computer. If you configure these ports as DMZ ports in the LAN or DMZ screen through the web configurator, you can also use Ethernet cables to connect public servers (web, e-mail, FTP, etc.) to the LAN/DMZ ports. 2Use another Ethernet cable to connect the WAN port to an Ethernet jack with Internet access. Use the blue console cable if you want to connect the CONSOLE port to your computer. Use the black dial backup cable if you want to connect the AUX port to an analog modem. 3Insert a 3G wireless card into the card slot on the side panel to access the Internet wirelessly via a 3G network. At the time of writing, you can only use the Sierra AC850/860 3G wireless card in the ZyWALL. 4Use the included power adaptor to connect the power socket (on the rear panel) to a power outlet. 5Look at the front panel. The PWR LED turns on. The CARD, LAN/DMZ and WAN LEDs turn on and stay on if the corresponding connections are properly made.ENGLISH 3 If none of the LEDs are on, check your connections, and inspect your cables for damage. Make sure that you have the power adaptor connected to the ZyWALL and plugged in to an appropriate power source. Make sure the power source is turned on. If the LEDs are still off, contact your local vendor. 2 Accessing the Web Configurator Use this section to configure the WAN 1 interface for Internet access. If the login screen does not display, check your browser’s security settings and make sure your computer’s Ethernet card is installed and functioning properly. Your computer should be also set to get an IP address automatically from a DHCP server. See Set Up Your Computer’s IP Address for more information. 1Launch your web browser. Enter 192.168.1.1 (the ZyWALL’s default IP address) as the address. 2Click Login (the default password 1234 is already entered). ENGLISH 4 If you changed the password and have forgotten it, you need to return the ZyWALL to the defaults (password is 1234, LAN IP address is 192.168.1.1, etc.). Press the RESET button (on the rear panel) until the PWR LED starts to blink, then release it. 5The HOME screen opens. The ZyWALL is in router mode by default. Continue to the next step if you want to use routing features such as NAT, DHCP and VPN. Go to section 3 if you prefer to use the ZyWALL as a transparent firewall. 6Check the network status table. If the WAN 1 status is not Down and there is an IP address, go to section 5. If the WAN 1 status is Down (or there is not an IP address), click the Wizard icon and use section 4 to configure WAN 1. 3Change the login password by entering a new password and clicking Apply. 4Click Apply to replace the ZyWALL’s default digital certificate. ENGLISH 5 Use the NETWORK WAN screens if you need to configure WAN 2. You can also configure load balancing between the WAN connections. 3 Bridge Mode When you set the ZyWALL to bridge mode, it functions as a transparent firewall. Do the following to set the ZyWALL to bridge mode. 4 Internet Access... »