Notice COOLER MASTER Sileo 500

« )• 6 x guide rail• Mounting material• NameQuantityUsage Spacers9Fasten motherboard #6-32 screw19Fasten motherboard and power supply unit M3 screw19CD-ROM / FDD / 3.5” bracket Cable ties1Arrange cables Magnetic ring1Arrange cables Saddle1Fasten cable ties Guide rails6Installation of 3.5” components 1 x silica gel bag• Operating instructions• Safety instructions3. We do not assume liability for resulting damages to property or personal injury if the product has been abused in any way or damaged by improper use or failure to observe these operating instructions. The warranty/ guarantee will then expire! The icon with exclamation mark indicates important information in the operating instructions. Carefully read the whole operating instructions before operating the device, otherwise there is risk of danger. Personal safety Be careful of sharp edges of the case so as not to injure yourself. • The product is not a toy and should be kept out of reach of children!• Product safety When used in conjunction with other devices, observe the operating instructions and safety notices of • connected devices. The product must not be subjected to heavy mechanical stress.• The product must not be exposed it to extreme temperatures, direct sunlight, intense vibration, or • dampness. If there is reason to believe that safe operation is no longer possible, the device is to be put out of operation • and secured against unintended operation. Safe operation is no longer possible if the device: shows visible damages, - no longer works, - was stored under unfavourable conditions for a long period of time or - was subject to considerable transport stress. - Miscellaneous Servicing, adjustment or repair works must only be carried out by a specialist/ specialist workshop.• If any questions arise that are not answered in this operating instruction, contact our Technical Advisory • Service or other experts. Installation4. Electrostatic discharge can damage system components. If an ESD-controlled workstation is not available, wear an antistatic wrist strap or touch an earthed surface before handling any PC components. Do not work on a carpet. For detailed instructions, please refer to the supplier’s manual. Place the case upright on a ?at, stable, clean and well-lit surface.1. Remove the front panel by pulling out the bottom ?rst, then the top. To replace it, push it back in place.2. Remove the 5.25” drive bay faceplates from the positions you are going to use. Removed faceplates cannot 3. be reinstalled. Loosen the two locking screws on the right side of the enclosure’s back with the aid of a screwdriver and 4. push the side screen to the rear. The side screen is mounted in the enclosure. When reinstalling, arrange the hooks of the side screen in a line with the appropriate openings of the computer frame. Push the side screen forward and fasten the screen with the locking screws. This manual includes only general guidelines for installation of the motherboard, power supply, peripheral devices, hard disk and PCI slots. It does not include instructions for CPU, RAM etc. For speci?c mounting instructions, safety instructions and troubleshooting, please consult the manuals that came with your other computer components. Motherboard Bring the motherboard screw holes to the height of the enclosure screw holes (inside the enclosure).1. Screw the spacers into the corresponding enclosure s... »