Notice BROAN HG80I

« r greater efficiency, we recommend you install the hood in the ducting version (if possible). The 2-motor version hood is only available for ducting version installation. INSTALLATION ATTENTION: 2 people are required for proper installation; the unit should be installed by a qualified operator. INSTALLATION IN DUCTING VERSION: 1.Before fixing, the disposal duct for air evacuation to the outside must be installed. Use an disposal duct with: – minimum indispensable length; – minimum possible bends (maximum angle of bend: 90°); – certified material (according to the State); – an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section. We recommend using a 150 mm diameter pipe for model shown in Figure 3, and a 200 mm diameter pipe for the model shown in Figure 4. For air evacuation to the outside, follow all the other instructions given on the “Warnings” sheet. 2.If you have purchased the 2-motor version (model shown in Fig. 4), you must fit the plastic flange using 4 screws (the screws are provided and are the 4 shortest ones). 3.Prepare a suitable power supply. For the electrical connection, follow all the other instructions on the “Warnings” sheet. 4.Check to see the grease filters have been removed; if necessary, remove these by moving the catch (B) and turning these outwards (Fig. 5). 5.Make a hole for housing the appliance (Fig.6) in the bottom of the wall unit. The bottom of the wall unit must have a thickness of between 15 and 20 mm. 6.Take 4 retention screws from the accessories bag (if you have purchased the 55 cm width model, use the 4 shorter screws). Fit the appliance in the hole made on the wall unit, first positioning the rear part, so the flap on the back rests on the wall unit; next, slightly slide the appliance back, towards the wall (Fig. 7). Without leaving the appliance, secure this to the wall unit by means of the 4 screws (Fig. 8). 7.Proceed with final fitting, using the 4 screws (the longest ones); See Fig. 9. 8.Connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and lock it to the air evacuation pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Make the electrical connections. 9.Refit the grease filters. INSTALLATION IN FILTERING VERSION: Proceed with installation, making reference to the instructions for the extraction version (see points 3, 4, 5, 6, 7), and then follow the instructions below. Connect the hose to the hood air outlet so the air is conveyed to the top of the wall unit; secure the hose with a metal clamp (hose and clamp are not provided). Make power connections. Check whether the charcoal filters have already been fitted. If necessary, proceed to fit these as follows: rest the charcoal filter on the motor unit by making the pins coincide; turn the charcoal filter until this is fast (Fig. 10). Refit the grease filters. OPERATION Depending on the model, the unit is equipped with the following controls: Controls shown in Fig. 11: Button A = turns the lights on/off. Button B = turns the TIMER on/off: press once to turn the timer on, therefore, after 5 minutes, the motor cuts out (at the same time the selected speed blinks on the display); the timer remains on if the motor speed is changed. Display C = - indicates the selected motor speed (from 1 to 4); - indicates Timer On when the number blinks; - indicates Filter Alarm when the central segments is on o... »