Notice KENWOOD Centrale vapeur IC400

« ock. Always unplug the steam station when filling the boiler. Don’t let the power and steam supply cords touch hot parts. Don’t let infirm people use the steam station without supervision. During ironing pauses and after use always place the iron flat on the iron rest of the steam station. Never leave the steam station on unattended. Never use a damaged steam station. Get it checked or repaired: see ‘service and customer care’. Only use this appliance for its intended domestic use. Don’t let children play with the steam station. Don’t touch the appliance with wet or damp hands. Always unplug the steam station when not in use and allow to cool before moving or cleaning. It is extremely dangerous to direct the steam towards people or animals. Only use water with this appliance. During use, the steam station must be stable and used in a horizontal position. before plugging in Make sure your electricity supply is the same as the one shown on the underside of the steam station. This iron complies with European Economic Community Directive 89/336/EEC. before using for the first time 1Remove all packaging and any stickers or labels. 2Wind excess cord around the base of the steam station. 3Test the iron on an old cloth to make sure the soleplate and boiler are clean. We recommend that you allow steam to disperse by pressing the steam button in order to release any residues that may have built up during the manufacturing process. Repeat step 3 after prolonged periods of storage. know your Kenwood steam station lock for continuous steam steam button temperature control with indicator light soleplate funnel boiler cap cord cactus locations steam supply cord cord storage variable steam control low water indicator light on/off button ready to steam indicator light iron rest power supply cord cord cactus 2 using your steam station 1Place the steam station on the support of the ironing board or any other stable surface nearby with the iron sitting on the iron rest. Make sure the steam station is unplugged and that the power and steam supply cords are unrolled and not kinked. 2Fit the cord cactus into one of the cord cactus locations. Place the steam supply cord into one of the grooves on the other end of the cord cactus. This will keep the cord in an upright position. filling with water 1Unscrew the boiler cap by turning anticlockwise. 2Use the funnel to fill the boiler. Maximum capacity when empty is 0.9 l. Take care not to overfill if the steam station contains water. 3Refit the cap, don’t overtighten. Filtered water is best as it reduces limescale, prolonging the life of your steam station (Kenwood water filters are widely available). Alternatively use tap water. refilling the boiler The red low water indicator light will glow when the boiler requires filling. NEVER UNSCREW THE BOILER CAP AS LONG AS THE BOILER IS UNDER PRESSURE. Carry out the following procedure to release the pressure:- 1Press the steam button until the steam stops coming out - this may take several minutes, then release the steam button. 2Wait until the red low water indicator light comes on, then press the steam button again to release any residual steam. 3Switch off and unplug the steam station and wait 5 minutes. 4VERY SLOWLY unscrew the boiler cap. If any steam is heard, stop unscrewing the cap and wait until all the steam... »