Notice PHILIPS RQ1075

« e, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. -Children should be supervised to ensure that they do not play with the appliances. Caution -Do not use the shaver, the Jet Clean System, the Power Pod or the adapter if it is damaged. -Charge and store the shaver at a temperature between 5°C and 35°C. ENGLISH -Always put the protection cap on the shaver to protect the shaving heads when you are travelling. -Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. -Only use the adapter supplied. -If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. -Only use the Jet Clean System with the original HQ200 cleaning ?uid. -Never immerse the Jet Clean System in water nor rinse it under the tap. -Use and store the Jet Clean System at a temperature between 5°C and 35°C. -Always place the Jet Clean System on a stable, level and horizontal surface to prevent leakage. -Empty the cleaning chamber and clean it thoroughly by rinsing it with hot tap water every 15 days. -Always place the Jet Clean System on a ?uid- resistant surface. -The Jet Clean System thoroughly cleans but does not disinfect your shaver, therefore do not share the shaver with others. -The cleaning chamber of the Jet Clean System is not dishwasher-proof. -When the Jet Clean System is ready for use, do not move it to prevent leakage of cleaning ?uid. -Never immerse the Power Pod in water, nor rinse it under the tap. ENGLISH7Compliance with standards -The shaver complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. -These Philips appliances comply with all standards regarding electromagnetic ?elds (EMF). If handled properly and according to the instructions in this user manual, the appliances are safe to use based on scienti?c evidence available today. General -The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts. Overview (Fig. 5) A Protection cap B Shaving unit C Trimmer D Trimmer on/off slide E Shaver (RQ1090/RQ1062/RQ1060/RQ1052/ RQ1050) F Shaver on/off button G Display H Shaver holder I Jet Clean System (RQ1005/RQ1000) J Jet Clean System on/off button K Cleaning symbol L Drying symbol M ’Cleaning chamber empty’ symbol N Cleaning chamber O Power Pod P Cleaning brush Q Adapter R Small plug ENGLISH8The display Before you use the shaver for the ?rst time, remove the protective foil from the display. The ?ve shaver types (RQ1090, RQ1062, RQ1060, RQ1052 and RQ1050) have different displays, which are shown in the ?gures below. -RQ1090 -RQ1062/RQ1060 -RQ1052/RQ1050 Charging -Charging takes approx. 1 hour. -When you place the shaver in the Jet Clean System or in the Power Pod, the display automatically switches off after approx. 5 hours. RQ1090 -When the shaver is charging, the minutes indication and the plug symbol ?ash. -The shaving minutes increase until the shaver is fully charged. ENGLISH9RQ1062/RQ1060 -When the shaver is charging, the plug symbol ?ashes. -First the arrowheads of the bottom charge level ?ash, then the arrowheads of the second level ?ash, and so on until the shaver is fully charged. RQ1052/RQ1050 -When the sh... »