Notice SIEMENS EC715QB80E

« ards and the country's electrical and gas supply companies' specifications. It is recommended that you call our Technical Assistance Service for adaptation to other types of gas. Before you begin, turn off the appliance's electricity and gas supply. This appliance has been designed for home use only, not for commercial or professional use. This appliance cannot be installed on yachts or in caravans. The warranty will only be valid if the appliance is used for the purpose for which it was designed. Before installing, you need to check that local distribution conditions (gas type and pressure) and the appliance's adjustment are compatible (see table I). The appliance's adjustment conditions are written on the label or the specifications plate. This appliance can only be installed in a well-ventilated place in accordance with existing regulations and ventilation specifications. The appliance must not be connected to a combustion product evacuation device. The supply cable must be attached to the unit to prevent it from touching hot parts of the oven or hob. Appliances with electrical supply must be earthed. Do not tamper with the appliance's interior. If necessary, call our Technical Assistance Service. Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. The units next to the appliance must be made of non-flammable materials. The laminated covering and glue for adhering it must be heat resistant. This appliance cannot be installed above fridges, washing machines, dishwashers or similar. An oven must have forced ventilation to install a hob above it. Check the oven's dimensions in its installation manual. If an extractor fan is installed, you must follow the installation manual's instructions, always keeping a minimum vertical distance of 650 mm to the hob. Preparation of kitchen unit (fig. 1-2) Make an appropriate size cut in the work surface. If the hob is electric or mixed (gas and electricity) and there is no oven below, place a non-flammable separator (e.g. metal or plywood) 10 mm from the bottom of the hob. This will prevent access to the base of the hob. If the hob is gas, it is recommendable to place the separator at the same distance. On wood work surfaces, varnish the cutting surfaces with a special glue. This protects them from moisture. Installation of appliance Depending on the model, the adhesive seal may be factory-fitted. If this is the case, it should not be removed under any circumstances, since the adhesive seal prevents leaks. If the seal has not been factory-fitted, apply it to the underside of the hob. Fig. 3. In order to fit the appliance into the kitchen unit, tighten each of the clips as indicated allowing them all turn freely. Insert and centre the hob. Press the sides of the hob until it is supported around its entire perimeter. Turn the clips and tighten them fully. The clips position depends on the thickness of the work surface. Fig. 4 Removal of hob Turn off the appliance's electricity and gas supply. Unscrew the clips and proceed in the reverse order to installation.Gas connection (fig. 5) The end of the inlet connection point of the gas hob has a 1/2” (20.955 mm) thread that allows for: - fixed connection. - connection using a flexible metal pipe (L min. 1 m - max. 3 m).... »