Notice NAD 916

« magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intend- ed to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance Note to CATV system installer: This reminder is provided to call the CATV installer's attention to Article 820-40 of the NEC , which provides guidelines for proper grounding and, in particular, specifies that the cable should be connected to the grounding system of the building, as close to the point of cable entry as practical. NAD 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SEVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. AFIN DEVITER UN CHOC ELECTRIQUE, ET LES CONSEQUENCES GRAVES QUI POURRAIENT EN RESULTER, TENTEZ PAS D'OUVRIR L'APPAREIL ET DE TOUCHER AUX COMPOSANTS INTERNES SANS LA PRESENCE D'UNE SERVICE PERSONNEL. ©1995 NAD ELECTRONICS LTD. 916NAD 3 FRONT PANEL CONTROLS Figure 1. ©1995 NAD ELECTRONICS LTD. 916NAD 4 GB A NOTE ON INSTALLATION This unit may be installed on any sturdy, level sur- face. Since its power transformers generate a mag- netic hum field of moderate strength, a turntable (especially one with a moving-coil pickup cartridge) should not be located near the amplifier. The amplifier requires ventilation. Do not obstruct the air outlet grilles on the top or bottom covers, and do not place the amplifier on a rug or other soft sur- face. Do not place the amplifier in an enclosed situa- tion such as in a bookcase or in a cabinet. SAFETY WARNING:Please ensure that the Volume controls at the rear of this amplifier are set to minimum level (i.e. COUNTER CLOCKWISE, viewed from the back panel). If this piece of equipment is to be used in a multi- room ouput of a NAD product, please ensure that before turning on the system for the first time, the Volume controls on any auxiliary amplifier ARE SET TO THE MINIMUM LEVEL. The multi-room output is not affected by the Volume or Tone controls (Treble, Bass) of the main system controls, so care must be taken to prevent auxiliary amplifiers being driven at full output level. WARNING TO UK USERS.If this appartus is not fitted with a UK three-pin plug, do not attempt to insert the attached plug into a UK mains socket. Instead, cut the plug from the mains lead and attach a fused UK three-pin plug using the following safety advice on wiring. IMPORTANT.The wires in this mains lead are coloured BLUE and BROWN; BLUE: NEUTRALBROWN: LIVE The colours of these mains lead wires may not cor- respond with the coloured markings identifying the terminals in your plug. In this case the BROWN wire must be connected to the terminal which is marked L(ive) or coloured RED. The BLUE wire must be con- nected to the terminal marked N(eutral) or coloured BLACK. No connection should be made to the termi- nal marked E or coloured green or green and yellow REAR PANEL CONNECTIONS 1. AC LINE CORD Plug the AC line cord into a nearby wall outlet that provides the correct AC power line voltage, or into a switched convenience outlet on your preamp. 2. INPUTS Each of the three independent stereo power ampli- fiers within the 916 has its own pair of inputs and out- puts. Before making connection... »