Notice PANASONIC ES-RW30

« ed if not used correctly. Check that the foil is not damaged before using the shaver. Do not use the shaver if the foil etc. is damaged as you will cut your skin. Charging the shaver Do not use any charging adaptor other than one speci?cally designed for this model (RE7-52). Plug in the adaptor into a household outlet where there is no moisture and handle it with dry hands. The shaver may become warm during use and charging. However, this is not a malfunction. Do not charge the shaver where it will be exposed to direct sunlight or other heat sources. Adequate ambient temperature for charging is 0-35 °C. The supply cord cannot be replaced. If the cord is damaged, the appliance should be scrapped. Cleaning the shaver Warning - Remove the shaver from the charging adaptor before     cleaning it to prevent electric shock. If you clean the shaver with water, do not use salt water or hot water. Do not soak the shaver in water for a long period of time. Wipe it with a cloth dampened with soapy water. Do not use thinner, benzine or alcohol. Storing the shaver Remove the shaver from the charging adaptor when storing it. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Keep these operating instructions in a safe place. SPECIFICATIONS Power source: See the name plate on the product. Motor voltage: 1.2 V DC Charging time: 8 hours This product is intended for household use only. Airborne Acoustical Noise: In shaving mode: 59 (dB (A) re 1 pW) In trimmer mode: 63 (dB (A) re 1 pW) 3 English Parts identi?cation            A Protective cap B Outer foil section 1 System outer foil 2 System outer foil release buttons 3 Foil frame C Inner blades D Main body 4 Foil frame release buttons 5 Switch lock button 6 OFF/ON switch 7 Appliance socket 8 Trimmer 9 Trimmer handle E Charging adaptor (RE7-52) : Charging plug ; Charge indicator lamp Cleaning brush ChargingCharge Perform the following steps to charge the shaver if it seems to lose the speed. You can fully charge the shaver in 8 hours. A full charge will supply enough power for approx. 7 shaves of 3 minutes each. 11Turn off the shaver and insert it in the charging adaptor as illustrated. 22Plug in the adaptor into a household outlet. The charge indicator lamp glows and stays on until the shaver is removed from the charging adaptor. • •4 EnglishUsing the shaverShave 11Depress the switch lock button and slide the OFF/ ON switch upwards. 22Hold the shaver as illustrated above and shave. Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave. • Using the trimmer Slide the trimmer handle up. Place at a right angle to your skin and move downwards to trim your sideburns.  CleaningClean 1. Remove the shaver from the charging adaptor. 2. Apply so... »