Notice REMINGTON S8102

« trol to suit hair type and length - 160 – 230°C I Switch lock function – Set the desired temperature by pressing +/- buttons and lock the switch settings by pressing the ‘-‘ button for 2 seconds. A ‘padlock’ symbol will appear on your LCD screen. This will prevent accidentally changing the temperature settings while using the straightener. To unlock the switch settings, press and hold the ‘-‘ switch again. J Turbo Boost function – automatically sets to the highest temperature. Hold the ‘+’ button for two seconds and the temperature will boost to 230°C K Automatic safety shut off – Unit will automatically switch itself off if left on after 60 minutes. If no button is pressed the unit will turn itself off. L Plate lock for storage – Push out the hinge to release and push the hinge in to lock M Includes heat proof pouch N 3m salon length swivel cord 3 year guarantee 1 ENGLISH GB 070939 REM IFU S8102-8203 INT_16L.indd GB_1070939 REM IFU S8102-8203 INT_16L.indd GB_115.01.2008 13:55:26 Uhr15.01.2008 13:55:26 UhrENGLISH 2 INSTRUCTIONS FOR USE Wash and condition your hair as normal. Towel-dry hair thoroughly, removing all excess water. Comb carefully through your hair, making sure it is free from snags or tangles. Plug in your wet2straight™ and switch it on. The LCD display will light up. Adjust the temperature buttons to suit your preference. When the required temperature has been reached the LCD display will be solid. 160 - 200°C - recommended for ?ne, damaged or fragile hair 200 - 230°C - recommended for thick or dif?cult to straighten hair Divide hair into manageable sections and prepare to straighten the lowest sections of your hair ?rst. Starting at the base of the neck, place a section of hair between the plates, ensuring that the vents top of the straightener are directed away from the face/scalp. Remember: the smaller the sections, better the results. Close the plates and immediately glide the straightener down the section of hair - gently moving from roots to tip. When the water in your towel-dried hair comes into contact with the hot plates, you will hear a loud hiss and may see some steam. This is a good thing- it’s the sound of the excess water in your hair evaporating and is not harmful to the condition of your hair. The water acts as a barrier between your hair and the heat, and ensures the cuticle is closed prior to straightening. Continue to run the section of hair between the plates until the preferred straightening and drying is achieved. For thicker hair, you may need to go over sections more than once. BETTER RESULTS Results with wet2straight™ are better than with a normal straightener because the cuticle is not being roughened up by the hairdryer. Instead, it lies ?at from wet to dry, leaving hair shiny, smooth and protected. DO’S Do ensure vent holes are directed away from face, head or hair. Do make sure hands are dry before using wet2straight™ and don’t hold them over the vent holes. Do use wet2straight™ on dry hair if required. Do use wet2straight™ on wet hair - just ensure hair is towel-dried before use. DON’TS Don’t allow dripping wet hair to come in contact with this straightener. Don’t use a normal ‘dry’ straightener on wet hair. Don’t be alarmed when you hear a hissing sound and see steam - it’s the sound of the excess water. When wet2straight’s plates come in... »