Notice SONY DCR-IP7E

« ction, problems with storage media, etc. Precautions •Before using the network function, be sure to set up the clock of the camcorder. For details, refer to the operating instructions of the camcorder. If you use the network function without setting the clock, you may not be able to send or receive e-mail, or view a Web page. •Do not remove the battery pack or disconnect the AC power adaptor while in NETWORK mode. The setup for the NETWORK mode may be lost. Also, exit the NETWORK mode when setting the POWER switch to OFF (CHG) or switching the mode. •We recommend that you make backup copies of your e-mail messages and your network preferences. These may be lost from time to time due to memory corruption. To save the network preferences, write them down on paper, or use “Setup memo”, described on page 77. Also, this data may be lost when the camcorder is repaired by repair services. •The reset button cannot reset the network preferences. Note on network operation when using the battery pack When the remaining battery time is insufficient in NETWORK mode, use the AC power adaptor or replace the battery pack with a fully charged battery pack. Before connecting the AC power adaptor or replacing the battery pack, be sure to exit the NETWORK mode. Note on the network function The network function is only available in the following countries or areas: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Luxembourg, Netherlands, Norway, Portugal, Sweden, Switzerland, United Kingdom, and Spain. (As investigated by Sony Corporation on 1. 8. 2001) When using the camcorder in a country or area not described above, the network function is available only in the country or area where you purchased the camcorder. For customers in CANADA Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment that is installed outdoors is subject to licensing.3-GB Introduction Table of contents Introduction The network function on the camcorder...4 Overview of the Bluetooth wireless technology..............................................5 Basic operations in the NETWORK mode........................................................6 How to use the Network Menu..........6 How to use the control button............7 How to input characters......................8 How to use the menu bar on the browser.........................................13 Preparation Registering a Bluetooth device.................15 When using the Modem Adaptor with Bluetooth Function.............15 When the registration has failed......19 Displaying information on your camcorder.....................................19 Radio wave indication.......................20 Selecting other Bluetooth devices from the list..................................20 Deleting a registered Bluetooth device from the list......................20 Setting network preferences.....................22 Setting your provider preferences...22 Setting network options preferences ........................................................26 Network Operation Using e-mail................................................29 Sending e-mail.... »