Notice HOOVER TFS 7208

« appliance or its controls.Please supervise the use of the appliance by older children, the elderly or the infirm. IT IS IMPORTANT THAT YOU DO NOT •Position the cleaner above you when cleaning the stairs. •Use the cleaner out of doors on wet surfaces or for wet pickup. •Pick up matches, hot ash, cigarette ends, hard or sharp objects or anything that may damage the cleaner. •Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours as this may cause risk of fire/explosion. •Run over the supply cord whilst using the cleaner or remove the plug by pulling on the cord. •Stand on or wrap the power cord around arms or legs when using the cleaner. •Continue to use your cleaner if it appears to be faulty.If the supply cord is damaged, stop using the cleaner IMMEDIATELY.To avoid a hazard, an authorised Hoover service engineer must replace the supply cord. •Remove the cyclonic cassette before removing the hose from the cleaner. •Use the appliance to clean people or animals. GB Nanopack cyclonic t7_V2.qxp 12/03/2007 17:32 Page 12 ASSEMBLING YOUR CLEANER Remove the cleaner and accessories form their packaging.Please dispose of the packaging material in a safe and conscientious way. Insert the hose end into the cleaner, ensuring it clips and locks into position.To release:simply press the two buttons on the hose end and pull (P1). Fit the hose/handle and floor nozzle onto opposite ends of the telescopic tube (P2 & P3).The accessory tools can be stored on the tool holder fixed to the telescopic tube (P3). USING YOUR CLEANER Power supply - Pull cord and plug into power supply (P4).Please make sure the cord is fully extended before using the cleaner.Press the on/off pedal once to start the cleaner (P5).Press it again to stop the cleaner before removing the plug after use.Press the cord rewind button to wind the power cord back into the cleaner (P6). Fixed power control (depending on model)- Adjust the suction by moving the handle valve:suction will decrease when opening the valve (P7).Use low suction for delicate fabrics. Variable power control (depending on model)- Slide the variable power adjuster to increase or decrease the suction (P8).Use low suction for delicate fabrics. Telescopic Tritube – The telescipic Tritube can be extended or collapsed by pressing the latches forward and pulling or pushing the tubes to the desired length (P9). Carpet & Floor Nozzle- Press pedal on the nozzle to lower the brush head when cleaning hard floors (P10).Press the pedal again to lift the brush head when cleaning carpets. Mini Turbo Nozzle (depending on model)- Use the mini turbo nozzle (P11) for deep cleaning on textile surfaces.Important:do not use the Mini Turbo Nozzle on rugs with long fringes, animal hide and with carpet piles deeper than 15mm.Do not keep the nozzle stationary while the brush is rotating. Multifunction Tool- (P12) This tool can be used as: 1.Crevice tool:for corners and hard to reach areas 2.Dusting brush:for bookshelves, frames, keyboards etc. GB Nanopack cyclonic t7_V2.qxp 12/03/2007 17:32 Page 23 Furniture Nozzle (depending on model) - For soft furnishings and fabrics (P12). Parking and storage- The telescopic Tritube can be parked for temporary storage during cleaning or in the storage position when not in use (P13 & P14). Nanopack Storage System-The unique Nanopack Storage System allows the cleaner to be stored in an ultra compact configuration with... »