Notice HOOVER TW 1780

« r and accessories from packaging. Please dispose of the packaging in a safe and environmentally conscientious way. Open the top cover (1) ensuring that the bag , pre-motor filter (2) and exhaust filter (3) are fitted correctly. Close the top cover. Insert the hose end into the top cover, ensuring it clips and locks into position (4). To release simply press in the two latches and pull. Fit extension tube (5), floor nozzle (6), and other accessories as required for use. Your cleaner is now ready for use. Extract the plug and pull out all of the cord. Plug in and switch on. (7) FEATURES On/Off button (8). Once plugged in, press this button to start the cleaner. Press it again to stop the cleaner before removing the plug after use. Cord rewind button (9). Remove the plug from the power supply. Press this button to wind the power cord back into the cleaner. Bag Check Indicator.(10) When activated this device warns that the bag requires to be replaced or emptied. Please refer to chapter, “Replacing the bag / Emptying permanent bag”. If after changing the paper bag or emptying the Permanent bag the Bag Check Indicator is still activated, a blockage has occurred. Please refer to chapter “Removing a blockage from the system”. Fixed power control (depending on model). Adjust the suction by moving the hose handle valve (11): suction will decrease when opening the valve. Use low suction for delicate fabrics. Variable power control (12) (depending on model). Rotate the control to increase or decrease suction. Use low suction for delicate fabrics. GB Sprint_MultiLan1.qxd 15/1/04 12:24 PM Page 56 Carpet and floor nozzle (6). Press pedal on the nozzle to lower the brush head when cleaning hard floors. Press the pedal again to lift the brush head when cleaning carpets. Dual function tool. Tool is stored on the Tool Holder (15) which is fixed to the Extension Tube. Remove tool and use as: a) Dusting brush for furnishings , bookshelves, frames, keyboards etc. b) Crevice tool [detach the dusting brush] for corners and hard to reach areas . c) A Furniture Nozzle is also stored on this Holder Tube Storage (14). The tubes can be stored into the storage slot underneath of the cleaner. REPLACING THE BAG/EMPTYING THE PERMANENT BAG REPLACING THE BAG (depending on model): When full (See “ Bag Check Indicator” paragraph) please dispose of the bag immediately. Open the top-cover and grip the bag holder. Lift the bag holder vertically out of the cleaner and remove the Bag from its holder (13). Dispose of the full bag into a bin . Fold and fit new bag into the bag holder (13). Replace the bag holder into the cleaner. Use only genuine Hoover bags. EMPTYING THE PERMANENT BAG(depending on model): When full (See “ Bag Check Indicator” paragraph) please empty the bag immediately. Open the top-cover and grip the bag holder. Lift the bag holder vertically out of the cleaner. Remove the Permanent Bag from the bag holder (13). Remove the plastic slide at the end of the bag allowing dirt collected to fall into the bin Refit the slide back into its original position. Fit the empty Permanent bag into the bag holder (13). Replace the bag holder into the cleaner (1). Check filters for excessive build up of dust. If required, clean or replace. Close the top-cover. See diagrams (2 & 3) to access the filters. To maintain best performance we recommend you wash the filters and the Permanent bag (dependi... »