Notice BRANDT AD289

« requirements, and our Customer Relations department is at your disposal, to answer all your questions and to listen to all your suggestions (see back cover of manual). Brandt has always been a leader in the development of new products, thus enhancing the quality of everyday life by providing increasingly effi- cient products, that are easy to use, respect the environment, and are attractive and reliable. The BRANDT name. IntroductionP.2 Know the various parts of your hood P.3 Safety recommendations P.3 Installation conditions P.4 Installing your hood P.5-8 Connecting your hood P.9 Using your hood P.10 Changing a bulb P.10 Cleaning your hood P.11 How to contact us P.12 Throughout this manual,indicates safety recommendations, indicates advice to help you make the best use of your duct 99625941_ML_A.qxd 18/11/02 13:47 Page 2GB Know the various parts of your hood? Light Metal filterControl buttons (see below) 123 Safety recommendations Lighting Switching off the hood Switching on the hood Max. speed Medium speed Low speed Please become familiar with the safety recommendations, before installing and using your hood. This hood is designed for normal household use. This hood contains no asbestos.- Do not allow naked flames to burn beneath the duct, i.e. do not cook " flambé " dishes or allow a gas ring to burn with no receptacle placed on it (extracted flames could damage the duct). - Frying under the duct should be constantly monitored. - Repair work should only be carried out by an approved specialist. - The metal filters should be regularly cleaned . - The hood must not be installed or used over a fuel burning (wood, coal, etc.) stove. To obtain optimum efficiency from your hood: - You should preferably use the rear cooking rings on your cooker. We recommend that the hood should be switched on from the beginning of the cooking and, in certain cases, may be allowed to run for a few minutes after the end of the cooking. Note: - When a cooking hood is used simultaneously with other equipment burning gasor simi- lar fuels, the room must be adequately ventilated. When the duct is running at max. power, the air in a kitchen is entirely evacuated, and thus replaced, in a few minutes. IMPORTANT - In the case of a kitchen heated by equipment connected to a chimney (e.g. a stove, etc.), the hood must be installed in recycling mode . - Do not use the hood without the metal filters. 3 99625941_ML_A.qxd 18/11/02 13:47 Page 34 Installation conditions If you have an air outlet to outdoors: Your hood can be connected to this outlet through an evacuation duct (enamel finished, in aluminium, flexi- hose or other non-inflammable material), with internal diameter 150 mm (not supplied). Otherwise, an adapter may be used to connect your hood to an evacuation duct with internal diameter 125 mm (supplied with your hood). If you have no air outlet to outdoors: All our units can be used in recycling mode (with no outlet to outdoors). In this case, an active carbon filter should be instal- led, to eliminate smells . These filters are available from your Brandt retailer, and the appropriate part number is shown on your duct identification plate (see inside the hood). Width: 900 mm Depth: 500 mm Overall height under conduit: 280 mm Min. - Max. height: 651mm -1106mm Outlet outer diameter: 150 mm(with non-return valve) or 125 mm. 99625941_ML_A.qxd 18/11/02 13:47 Page 4GB 5 I... »