Notice JVC KD-NX5000E

« 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. 3. CAUTION: Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical instruments. 4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED OUTSIDE THE UNIT. Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Caution: Changes or modifications not approved by JVC could void the user’s authority to operate the equipment. Caution: Never try to analyse or retrieve the data stored in the Hard Disk Drive (HDD). Otherwise, you may have your warranty invalid, and be penalized by law. The manufacturer assumes no liability for any damage resulting from such conduct as mentioned above. KDNX5000_E_en_rev.indb 2KDNX5000_E_en_rev.indb 230/3/07 2:01:09 pm30/3/07 2:01:09 pm3 When the temperature is low, the HDD may take some time to start up, or may reboot automatically. This unit does not function properly unless the speed signal lead is connected (refer to the Installation/Connection Manual). It may be unlawful to record or play back copyrighted material without the consent of the copyright owner. • DO NOT install any unit in locations where: – it may obstruct the steering wheel and gearshift lever operations. – it may obstruct the operation of safety devices such as air bags. – it may obstruct visibility. • DO NOT operate the unit while driving. If you need to operate the unit while driving, be sure to look ahead carefully. • The driver must not watch the monitor while driving. • If the parking brake is not engaged, “Parking Brake” flashes on the monitor, and no playback picture will be shown. – This warning appears only when the parking brake wire is connected to the parking brake system built in the car (refer to the Installation/Connection Manual). Hard Disk Drive (HDD) Installation This unit has a built-in HDD, which is a device to read minute magnetic changes. The inside of the device is precision components, requiring you to notice the following when installing the unit: Install the unit at a place where the following conditions are satisfied: • Dry and neither too hot nor too cold— between 5°C and 35°C. If the temperature is too low, the HDD will not work. Wait until the temperature in the car becomes normal before operating the unit. • At an altitude between –300 m below sea level and +3000 m above sea level. • With adequate ventilation to prevent internal heat buildup in the unit. Before using HDD While the unit is turned on, the hard disk is constantly rotating at a high speed. This requires you to notice the following: • DO NOT impart vibration or shock. • DO NOT allow anything having strong magnetism or emitting strong electromagnetic waves (mobile phones, etc.) near the unit. • DO NOT disconnect the power cords from the car battery when the unit is turned on. Failure in following the above cautions may damage the HDD (the stored data will be lost and be never restored). WARNINGS: To prevent accidents and damage For security reasons, a numbered ID card is provided with this unit, and the same ID number is imprinted on the unit’s chassis. Keep the card in a safe... »