Notice TARGUS Numeric Keypad

« it “clicks” firmly into place.Targus Wireless Numeric Keypad 4 This keypad is a plug and play device. It should automatically operate when the USB receiver is connected to the computer. Connecting to Your Computer 1. Remove the USB receiver from the back of the keypad. 2. Plug the USB receiver into an available USB port on your computer. 3. Power on the keypad by using the On/Off switch located on the back of the keypad. NOTE: WHEN THERE IS COMMUNICATION BETWEEN THE KEYPAD AND THE RECEIVER, THE LED ON THE RECEIVER WILL FLASH.Targus Wireless Numeric Keypad 5 • To extend the life of your battery, turn off the keypad while travelling or when you’re not using it. Power Management If the response time of the keypad is slow or it intermittently stops working: Re-Establishing a New Connection 1. Unplug the USB receiver from the computer. 2. Plug the USB receiver into another available USB port and the LED indicator will flash for 1 minute to indicate pairing mode is activated. 3. Power on the keypad and press the reset button to re-establish a new connection. Battery Life Indicator The light will turn on when the power is low and batteries need to be replaced.Targus Wireless Numeric Keypad 6 Technical Support Product Registration Targus recommends that you register your Targus accessory shortly after purchasing it. Go to: http://www.targus.com/registration.asp You will need to provide your full name, email address, country of residence and product information. Warranty Targus warrants this product to be free from defects in materials and workmanship for one year. If your Targus accessory is found to be defective within that time, we will promptly repair or replace it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage to devices; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental damages, even if Targus has been informed of their possibility. This warranty does not affect your statutory rights. For technical questions, please visit: Internet: www.targus.com/support.asp Email: info.cn@targus.com Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.Targus Wireless Numeric Keypad 7 FCC Statement Tested to Comply This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna; • Increase the separation between the equipm... »