Notice LENCO L69

« ore checking the mains voltage and before all other connections have been made. • Do not cover any vents and make sure that there is a space of several centimeters around the unit for ventilation. LOCATION OF CONTROLS 1) Dust cover 2) Spindle adaptor 3) AC cord 4) Audio cable 5) Pick-up holder 6) UP/DOWN selector 7) 33/45 rpm speed selector 8) REC button 9) SKIP - UP button 10) OFF/USB/PH selector 11) MODE button 12) SKIP - DN button 13) F - UP button 14) ID3/PROG button 15) STOP/SD button 16) PLAY/PAUSE button 17) LCD display 18) SD slot 19) USB slot 20) STOP button CONNECTION Audio connection The record player has an inbuilt preamplifier and can therefore be connected directly to the Line In / Aux input on a hi-fi system. • Connect the audio cable(4) to the Line In / Aux input on your hi-fi system (red plug = right channel; white plug = left channel). Mains connection 1. Connect the power cord to AC outlet 2. switch the OFF/USB/PH Selector to “ PH “ function. if ”PHONO” is displayed on the LCD display, it’s mean the power supply is normal. now your system is ready to play the music. PHONO NOTED: - remove the stylus protector. - be sure that the tone arm is being detached from the tone arm rest before operating and re-secured again afterwards. 1. Slide the OFF/USB/PH selector(13) to “PH” function, “PHONO” is displayed on the LCD display 2. Set the 33/45 rpm speed selector(7) to the proper position depending on the record to be played. 3. Place the record on the platter (use the spindle adaptor if required). 4. Slide the UP/DOWN selector(6) to “UP” position 5. Lift the tone arm from the rest and slowly move it to the record side. the platter will start to rotate. 6. Place the tone arm to the desired position of the record, Slide the UP/DOWN selector(6) to “DOWN” position 7. Adjust the volume to the desired level on your hi-fi system. 8. At the end of record, the platter will automatically stop rotating, lift the tone arm from the record and return it to the rest. 9. To stop manually, press the STOP Button(20) directly, or lift the tone arm from the record and return it to the rest E - 1 1 2 3 4 56 7 89101112131415 16 17 1819 20 OFF PH USB USB REC SD REC SKIP-U P SKIP-D N M ODE F- UP ST OP/SD ID3/PRO G PLAY/ PAUSE 33 45 UP DOWN STOPPHONO ENCODING 1. Insert the USB flash disk or SD card into appropriate slot(18)/(19). 2. Slide the OFF/USB/PH selector(13) to “PH” function, “PHONO” is displayed on the LCD display 3. select and playback at phono for the track which will be assigned to the encoded sounds on the USB flash disk or SD card. 4. Press once the “REC” button(10), the LCD display shows “USB” flashing/ “CARD” flashing. The encoding will starting after 10 seconds and shows “PHONO” with flashing words “USB” / “CARD” lower left corner of the LCD display. NOTED: Press twice the “REC” button(10) directly, the encoding will starting immediately. 5. To stop encoding, press “STOP” button(20). Re-mark: Do not interrupt during the phono recording process until completed. Otherwise,recording function cannot be performed. PLAYBACK OF MP3/WMA SONGS VIA USB FLASH DISK OR SD CARD STORAGE MEDIA 1. Insert the USB flash disk or SD card into appropriate slot(18)/(19). 2. Slide the OFF/USB/PH selector(13) to “USB” function, the unit will automatically read the total fol... »