Notice EASYPIX Easyscan A4

« parts Ready for scan: Green LED on Error LED indicatorOver speed: Red LED on 9 10 Format buttonPress this button to format the microSD card. Manual 11 Time setPress to enter Time setting mode 1 2 3 5 7 64 89 10113. Explanation of the status icons RESOLUTION HIGH LOW COLOR MONO FULL EFFECT 1 2 3 4 5 ItemFunctionDescription SD card indicatorPhotos will be stored in mSD card icro Battery indicatorBattery is full Empty battery Effect indicatorColor or Mono Counting indicatorShow scanned files in SD cardmicro Selected resolutionHigh:600 dpi / Low:300 dpi 1 2 3 4 5 4. Using the scanner 4.1 Installing the battery 1. Open the battery door. 2. Insert 2x AA alkaline batteries into the battery compartment. 3. Turn on the by pressing the [POWER] button for 2 seconds.scanner 4.2 Inserting a microSD memory card (not included) You must insert a microSD Card (not supplied) to record and store your pictures. Inserting the microSD memory card: 1. Turn OFF the scanner. 2. Insert the microSD card into the microSD card slot, gently press in until card is latched. Note: -Do not force the card into the slot; forcing may damage scanner and the microSD memory card. Align microSD card position (as marked) and try again. -The microSD memory card must be formatted before scanning. See the following instruction.4.5 Setting the resolution Press the [DPI] button to select High/Low resolution. High/Low resolution icon will be displayed on status LCD. 4.6 Setting the scan mode Press the [C/BW] button to select Color/Mono mode. Color/Mono icon will be displayed on status LCD. 4.7 How to scan Hold the document firmly by one hand. Place the scanner on the start-scanning position. Hold the scanner tight and press the scan button once. Slide the scanner slowly and keep your hand stable to get the best quality picture. Press again to stop scanning. 4.4 Formatting the microSD memory card 1. Insert a new SD card into the scanner, then turn on the scanner. 2. Press the format button into format mode. “F” shows on the LCD. 3. Press the Power/Scan button to start formatting the SD card. 4. SD card indicator will blink until format is complete. micro micro 4.3 Time setting 1. Press [TIME SET] to enter time setting mode 2. In the LCD, it shows 1 XX, and press (C/WB & DPI) buttons for up & down number selection 3. Press ( SCAN ) button to confirm setting 4. In the LCD, it jumps to next setting mode as below sequence 1 XX year setting 2 XX month setting 3 XX date setting 4 XX hour setting 5 XX minute setting 5. After all the information has been set, press ( TIME SET ) button again to exit OK5. LED light indications “GREEN” SCAN LED ON “GREEN” SCAN LED OFF Scan in progress. Standby/Scan is complete. Scanning too fast.May cause scanning error.Restart and scan again.“RED” ERROR LED ON “RED” ERROR LED OFFNo error in scanning speed.Continue scanning process. 6. Connect to computer You may also connect your scanner to your computer and view p on the computer monitor . ictures 7. Specification Image sensor A4 Color Contact Image Sensor Number of sensor5136 dots(1st~5104 dots available) ResolutionLow resolution : 300x300... »