Notice LG GP08NU6B

« ong type of cable with this drive can cause it to malfunction. • The machine does not have an ON/OFF switch. As soon as it is connected to the AC power, the power up sequence begins. The power supply cord is intended to serve as the main disconnect device. The power outlet shall be near the equipment and shall be easily accessible. • The appliance is not intended for use by young children or infirm persons without supervision. Young Children should be supervised to ensure that they do not play with appliance. • If the appliance is supplied from a cord extension set or an electrical portable outlet device, the cord extension set on electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture. Installation NOTES Connecting to computer Hardware Installation NOTES USB Power cable 1 2 31. Disc Tray 2. Drive activity indicator The LED is used to indicate the operation of drive. 3. Eject Button 4. Emergency Eject Hole 1. USB Connector (mini) This connector is used to connect to the USB 2.0 cable. Location and function of controls Removing the USB converter cable (For Windows) The drive supports the plug and play(not swap) function of Windows, and can be removed and inserted by performing the following operation. 1. Stop the application software being currently used. 2. Click the icon “ ” of the taskbar located on your screen’s bottom right side. 3. Click “Safely Remove USB Mass Storage Device-Drive[x:]”. 4. Click “Ok” and then remove the USB converter cable. 1234 This following is the general figure of the design of the drive. The drive’s appearance and specifications may change without prior notice. Front Rear 1 NOTE Don’t remove the USB 2.0 cable when the busy indicator on the drive blinks, or during computer startup. The removing procedure varies depending on your OS.Features • Universal Serial Bus (USB) 2.0 interface for high-speed data transfer. • Buffer Under Run error protection technology • Emergency eject support • Combination of CD-R/RW, DVD-R/RW, DVD+R/RW, DVD+R DL, DVD-R DLand DVD-RAM drive functions into one drive. • Supports region playback control Phase II. • PC USB powered, no AC adapter needed. System meeting the following requirements is needed in order to use USB 2.0 operation with this drive. •Computer that is equipped with a USB 2.0 – compliant USB connector or PCI adapter card, and on which the USB 2.0 EHCI (Enhanced Host Controller Interface) driver software 1)has been installed. 1)The USB 2.0 EHCI driver software is supplied with currently available PCI adapter cards that conform to USB 2.0. Further, Microsoft has released the USB 2.0 EHCI driver software for Windows XP, therefore it is also possible to use this driver software with Windows XPSP2. If you want to know in detail, please contact your USB 2.0 adapter dealer or consult your PC manufacturer, or consult the Microsoft Corporation Web site. System Environment Computer This unit can be operated in the system environment explained here. * For Windows 7/ Windows Vista, 1 GB of RAM or large is recommended. * Compatibility problem in write/read function may occur with some media depending on the media manufacturing quality. * To achieve maximum Record & Write speed your system may require data to be copied first to the computer’s hard drive rather than directly from another source disc or drive. Specifications Pentium IV 2.4... »