Notice CARRIER Régulateur Electronique HDB

« ......................................................................... 4 Wall-mounted bracket .............................................................................. 5 System con?guration ............................................................................... 5-6 Address selector ..................................................................................... 6 Installation manual INSTALLATION FLOW CHART Read manual Install 'IR2 Start the test to check the system. Operate the IR2GB - 2 HDB - IR A AM PM A B 1 2F 2861 181 63 2,5 32,8 77,2 85,7 87 A Dimension (mm) Wall-mounted bracket Remote control GB - 3 HDB - IR ENGLISH A AM PM A B 1 2F A B D E G H JK M N C F I L O BEEP A AM PM A B 1 2F • Remove the used batteries and insert new batteries. The remote control uses two alkaline batteries (1.5 V, LR03x2). • Press the reset button “O” with a sharp object to reset the remote control. • Do not use used batteries or batteries of different types, as this may cause the unit to malfunction. • The average battery life during normal use is approximately one year. The remote control used batteries must be disposed of according to the standards in force. • If the air conditioner does not operate normally after replacing the batteries, remove the batteries, re?t them and press the reset button “O” again after 5 seconds. The maximum operating range for the remote control is approx. 5 m. No obstructions such as curtains or plants should be between control and unit. Direct sun on the unit receiver may interfere with good signal reception. The control must be directed toward the unit receiver when pressing the buttons of the desired functions. An acoustical acknowledgement sound (beep) will indicate that signal has been received. The remote control operates with two 1.5 V non re-chargeable batteries. When the symbol appears in the display, this indicates that the batteries are exhausted. How to insert batteries: Open embedded cover. Remove the cover of the battery compartment at the back of the remote control by pressing the tab toward inside, in the direction of the arrow.  Display readout A. Mode selection button B. ON/OFF button C. Increase temperature button D. Decrease temperature button E. Fan speed selection button F. Personalised control button G. Personalised settings button H. Louvre control button (Flap) I. ON timer button J. DaILy timer button (Everyday) K. Cancel timer button L. OFF timer button M. Sleep timer button (night) N. Current time adjusting button O. Reset button General informationHDB - IR GB - 4 1. Operating mode (from left to right): • Ventilation (fan only) • Heating (according to the Unit con?guration) • automatic(according to the Unit con?guration) • Cooling and dehumidi?cation • Dehumidi?cation only 2. Signal transmission symbol 3. Temperature selected 4. Address selector 5. Temperature unit of measurement (°C or °F) AM PM A B 1 2F 3 5 7 8 10 12 13 1 2 4 6 9 11 14 15 6. Unit con?guration 7. Batteries exhausted indicator 8. Louvre positioning (Flap) 9. Fan speed 10. Personalisation active 11. ON timer selected 12. Night timer active 13. Daily timer active (Everyday) 14. ON timer, OFF timer and current time 15. OFF timer selected Display of selected functions General information The remo... »