Notice AEG ECLIPSE 10

« tions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. Keep this product away from hot, humid conditions or strong sunlight, and don’t let it get wet or use it near water (for example, near a bath tub, kitchen sink, and swimming pool). Do not overload wall outlets and extension cords as this can result in the risk of ?re or electric shock. Unplug this product from the wall outlet under the following conditions: >When the power supply cord or plug is damaged. >If the product fails to operate normally despite following the operating instructions. >If the product has been dropped and the cabinet has been damaged. >If the product exhibits a distinct change in performance. NEVER use your phone outdoors during a thunderstorm. Unplug the base from the telephone line and the mains socket when there are storms in your area. Damage caused by lightning is not covered by the guarantee. Do not use the telephone to report a gas leak in the vicinity of the leak. Use only the supplied NiMH (Nickel Metal Hydride) batteries that came with your phone or an authorized replacement recommended by the manufacturer. There is a risk of explosion if you replace the battery with an incorrect battery type. The use of other battery types or non-rechargeable batteries/primary cells can be dangerous. They may cause interference and/or damage to the unit or surroundings. The manufacturer will not be held liable for damage arising from such non-compliance. Do not use third party charging pods. Damage may be caused to the batteries. Please ensure that the batteries are inserted in the correct polarity. Dispose of batteries safely. Do not burn, immerse them in water, disassemble, or puncture the batteries. 3 INTENDED USE This telephone is intended to be connected to a public analogue telephone network or to an analogue extension of a compatible PBX system.4 INSTALLING YOUR PHONE 4.1 Connecting the Base Station (See P4) Plug the mains power cable (15) and telephone line cord (16) into the base station. Plug the power adapter into a 100 - 240Vac, 50 - 60Hz mains power socket and the telephone line cord into a telephone line socket. Warning: Always use the cables provided in the box. Use only the supplied adaptor. Using other power adapter may damage the unit. Note: Place the base unit within easy reach of the mains power socket. Never try to lengthen the mains power cable. The base station needs mains power for normal operation and the cordless handsets will not work without it. 4.2 Installing and Charging the Rechargeable Batteries Insert the 2 supplied batteries into the battery compartment, observing the correct polarity (see markings inside battery compartment). Warning: Use only the supplied NiMH rechargeable batteries. Place the back cover over the back of the handset and press down until it clicks into place. Place the handset on the base and charge for 15 hours before using the handset for the ?rst time. >The handset will give a double beep when it is properly placed on the base and the battery charging indicator on the base lights up to indicate charging. Note: The handset may become warm when the batteries are being charged or during prolonged periods of use. This is normal and does not indicate a fault. CAUTION Risk... »