Notice COLEMAN Tonnelle moustiquaire Insta-Clip 11x9

« Pole Assembly –You will need to assemble and connect one pole at a time to the hub. –Do not completely assemble poles. a)Beginning at spring-clip end of pole, assemble all but the last shock-corded section. The pole and one section should curve downward. (illus. 2) b)Insert the spring-clip end into one of the hub ports until it clicks into position. (illus. 1), (illus. 2) c. Repeat for each of the three remaining poles (illus. 2) 11’x9’ Insta-Clip Screen House 1 When You Are Ready To Set Up Your Shelter –Select a level area clear of rocks, branches and other hard or sharp objects. –Do not set up your shelter under trees. –For easier set up, two or more people are recommended. –Place fabric in center of selected location and assemble above fabric. ASSEMBLYPARTS Instructions apply to Part Number 9392-119 Poles (4) Part No. 9392-1081 Hub (1) Part No. 9392-1071 Illus. 2 Screen House laid out in position with partially assembled frame locked into hub. Illus. 1 Poles inserted into hub Hub Hub Frame Clips2 3 PRINTED IN CHINARev. 11/04 Things You Should Know• Never store shelter, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use separate storage bag.• STAKES SHOULD BE REMOVED BYPULLING ON THE STAKE ITSELF. NEVER PULLON THE SHELTER FABRIC OR STAKE LOOPTO REMOVE STAKE.• SHELTER POLES SHOULD NOTBE LEFTTELESCOPED TOGETHER DURING STORAGE. • Do not leave your shelter set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored. WARNING:Keep all flame and heat sources away from this shelter fabric. This shelter meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the shelter fabric may render the flame-resistant properties ineffective. THE COLEMAN CO., INC. 3600 N. Hydraulic • Wichita, Kansas 67219 1-800-835-3278 • www.coleman.com MADE IN CHINA Attach Shelter to Frame –With the frame still partially set up, clip the center of the Screen House to the center hub. (illus. 3) –Starting towards the center of the Screen House, clip the shelter fabric to the poles. Complete Shelter –Fully extend each pole by straightening all shock-corded pole sections. –Insert the pin on the pin and ring system, at the corner of the Screen House into the the pole end. (illus. 4), (illus. 6) –Repeat for remaining poles. –Adjust poles to pull the shelter taut and stake down through the fabric loops at the end of pin and ring. (illus. 5), (illus. 6) –Attach guy lines to fabric guy loops at each corner and stake out (illus. 6) illus. 3 Screen House clipped to partially assembled frame Start by attaching the center of the Screen House to the pole hub. illus. 4 Insert into the pole end illus. 6 Completed shelter with guy lines staked out illus. 5 Stake through stake loop »