Notice COLEMAN Screen Lodge

« Pole Assembly –Assemble and connect one pole at a time to the hub. –Do not assemble poles completely. –Go to the end of pole with the spring clip and assemble all but the last shock corded section.The pole should curve down plus one section.(illus.2) –Insert the end with the spring clip into one of the hub ports until it clicks into position.(illus.1, 2) –Repeat for each of the five remaining poles.(illus.2) 14’x12’ Screen Lodge 1 When You Are Ready To Set Up Your Shelter –Select a level campsite clear of rocks, branches and other hard or sharp objects. –Do not set up your shelter under trees. –For easier set up, two or more people are recommended. POLE ASSEMBLY PARTS Instructions apply to Part Number 9192-142 Poles Part No.9191-101 Hub Part No.9191-102 Illus.2 Partially assembled frame locked into hub Illus.1 Poles inserted into hub Hub Hub2 Things You Should Know• Never store tent, even for a short period of time, without drying it thorough- ly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.• TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.• Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored. WARNING:KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective. THE COLEMAN CO.,INC. 3600 N.Hydraulic • Wichita, Kansas 67219 1-800-835-3278 • www.coleman.com MADE IN SRI LANKA Attach Shelter to Frame –Drapethe shelter over the frame, positioning doors in the desired direction. –Position each corner over the curve portion of the pole. –Fully extend each pole by completing the interlocking of the shock corded pole sections. –Insert the brass hook into the hole near the base of the pole (illus.4, 5) –From the inside of the shelter secure the pole frame to the shelter with the hook and loop closures.(illus.6) –Adjust poles to pull the shelter taut and stake down through the fabric loops at the end of each pole (illus.5) –Adjust hook straps to increase tautness (illus.5) –Attach guy lines to fabric guy loops at each corner and stake out (illus.6) illus.3 Fabric draped over partially assembled frame illus.6 Completed shelter with guy lines illus.4 Insert Brass Hook into hole near the base of the pole illus.5 Stake through Stake Loop Use to adjust or tighten canopy Inside hook & loop »