Notice GEMINI PDT 6000

« INTRODUCTION: Congratulations on purchasing a Gemini PDT-6000 High-torque Direct Drive Digital Turntable. This state of the art turntable includes the latest features in modern direct drive turntable technology. Prior to use, we suggest that you carefully read all the instructions. FEATURES: • Quartz Locked Speed• Pitch Adjustment • Pitch Control• Key Adjustment • Brake and Torque Control• Digital Output • Strobe Illuminator• Phono/Line Output • Soft-touch Start/Stop Switch• Digital Display • Platter Reverse• Master Tempo Control • BPM Counter (Beats Per Minute) PRECAUTIONS: 1.Read all operating instructions before using this equipment. 2.The apparatus should not be exposed to dripping or splashing and no objects filled with liquids such as vases should be placed on the apparatus. 3.To reduce the risk of electrical shock, do not open the unit. There are NO USER REPLACEABLE PARTS INSIDE. Please contact the Gemini Service Department or your authorized dealer to speak to a qualified service technician. In the U.S.A., if you have any problems with this unit, call 1-732-738-9003 for customer service. Do not return equipment to your dealer. 4.Tone arm bearings are factory set and sealed. Any attempt at adjustment will void the warranty. 5.Be sure that all AC power is OFF while making connections. 6.Cables should be low capacitance, shielded and of proper length. Make sure that all plugs and jacks are tight and properly connected.7. Always begin with the audio level faders/volume controls set at minimum and the speaker volume control(s) set to OFF. Wait 8 to 10 seconds prior to turning up the speaker volume to prevent the transient “POP” that could result in speaker/crossover damage. 8.DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. 9.DO NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY CONTROLS OR SWITCHES. PARTS CHECKLIST: Turntable Unit...........................1 Dust Cover Hinge.....................2 Turntable Platter......................1 45 RPM Adapter........................1 Neoprenemat...........................1 Counter Balance......................1 Dust Cover................................1 Headshell..................................1 ASSEMBLY AND SET-UP: TURNTABLE INSTALLATION: 1.Set the TURNTABLE BASE (1) on a flat, level surface free of vibration. Try to place the unit as far away from the speakers as possible. Keep the unit away from direct exposure to the sun, heat, moisture or dirt. Keep the unit well ventilated. Use the turntable feet to horizontally stabilize the unit. 2.Make sure that the VOLTAGE SELECTOR SWITCH (3), located on the TURNTABLE BASE (1), is set to the correct voltage. WARNING: If you try to operate the turntable with the incorrect voltage setting, it can damage your turntable. 3.After checking to ensure that all packing materials have been removed, gently place the PLATTER (2) on the center spindle of the TURN TABLE BASE (1). 4.Put the NEOPRENE MAT (4) on the PLATTER (2). CARTRIDGE INSTALLATION: (SEE FIG.1) Because all cartridges have their own designs, please refer to your particular cartridge’s instructions to insure proper installation. 1.Connect the lead wires to the cartridge terminals. For your convenience, the terminals of most cartridges are color coded. Connect each lead wire to the terminal of the same color. White (L+).............................................Left Channel + Blue (L-)...................................... »