Notice PHILIPS SRU-4010

« l . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6 3.Keys and functions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Code list of all brands / equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52-58 Information to the Consumer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 1.Introduction Congratulations on your purchase of the Philips SRU 4010 universal remote control. After installing the remote control it can operate the most-used functions of almost any brand of TV.You can find information about how to prepare this remote control for use in the chapter ‘Installing the remote control’. 2.Installing the remote control Inserting the batteries1Press the cover inwards and slide it in the direction of the arrow.2Place two AAA type batteries into the battery compartment,as shown.3Slide the cover back and click it firmly into place. Testing the remote control The remote control has been programmed to operate most Philips devices.Because the SRU 4010 may use different signals for each brand and even for different models of the same brand,it is advisable to test whether your TV responds to the SRU 4010. The example below instructs you how to do this. 1Turn your TV on manually or use the original remote control.Tune to channel 1.2Check whether all the keys are working. For an overview of the keys and their functions, see ‘3.Keys and functions’. –If the TV responds as it should to all of the key commands the SRU 4010 is ready for use. •If the TV does not respond at all or not to all of the key commands,follow the instructions under ‘Setting the remote control’,or for online setup go to: www.philips.com/urc. Setting the remote control This is only necessary if your TV does not respond to the SRU 4010. If that is the case,the SRU 4010 does not recognize the brand and/or model of your TV and you need to program the remote control to do so. You can set the remote control either automatically or manually. 4 Instructions for use EnglishInstructions for use English 5 Manually setting the remote control1Turn on the TV manually or use the original remote control.Tune in to channel 1. 2Look up the brand of your TV in the code list at the back of this manual.One or more four-figure codes are shown for each brand.Note the first code. On our website www.philips.com/urc you can directly select your device typenumber to find the right code. 3Use a pen or paper clip to press the Setup key and keep it pressed for 5 seconds until the Standby key blinks twice and then remains lit. 4Then enter the code noted in step 2,using the digit keys. –The Standby key will now blink twice.If the key blinks once for an extended period,the code has not been entered properly or the wrong code has been entered. Start again from step 2. 5Point the SRU 4010 at the TV and check that it responds as it should. –If the TV responds to all of the key commands,the SRU 4010 is ready for use. Do not forget to note your code. •If the device does not respond at all,or not to all of the key commands,start again from step 2 and try the next code from the list. Automatically setting the remote control The remote control will now automatically search for the right code for your device. 1Make sure the TV is switched on and select a channel using the or... »