Notice THOMSON ROC 36

« (FF) :fast forwardfor VCRSand DVDS; press with bluekey for fast text function in TV mode. B(PLAY): plays a VCRtape or DVDdisk; press with yellowkey for fast text function in TV mode. K(PAUSE): Suspends play and stops on an image; press with magentakey for fast text function in TV mode. I/EXIT: Teletext Off in TV mode; turns off the menu of the selected product (SHIFT+ EXIT). PROG+/-: Programmes zapping button (rapid select); use to scroll vertically through menus (SHIFT+ PROG+/-). S/SHIFT:Programmes the remote control (S) or activates the secondary key features (SHIFT). 3: Press this key first before you type in the 2-digit channel number (except for Thomson group products). 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 This Universal Remote Control is compatible with most models of infrared-controlled TV sets, video recorders, DVD players, satellite and cable TV receivers. This remote control has already been programmed so that you can use it to control most of the audio/video products made by the THOMSON group. Before attempting to programme the remote control, install 2 batteries (AAA, not supplied) and try it out by using one of the methods described in this user manual. Please keep this guide along with the code list (provided separately), so that you can programme your remote control for use with other products. 1 - Description of the key functions 2 - Testing the remote control before you programme it 1.Turn on the product you want to control. 2.Press the product key (2) that corresponds to the type of product you want to control: TV: television setSAT: satellite receiver VCR: video recorder 3.Point the remote control towards the product and try to turn it off by pressing the BB key. If the product doesn’t turn off, you’ll need to programme the remote control by one of the methods described in chapter 3. EN 01-ROC 36 GB 26/02/04 18:22 Page 12 3 - Programming the remote control Method A – Fast programming with 1-digit subcode Method B – 3-digit codes programming Before you start programming, you must find the subcodeof the product to be controlled (Television, VCR, satellite receiver or DVD player). Refer to the list provided with these instructions, page I of the codes. 1.Turn on the product you want to control. 2.Hold down the Skey ( 17) until the red indicator lamp ( 1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). 3.Press the product key (2) that corresponds to the type of product you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver. 4.While the indicator is lit, type in the subcode (example: 1for THOMSON). 5.Point the remote towards the productand try to turn it off by pressing the key BB(11). 6. If the product you want to control turns off, press OK(8) to save the subcode. 7.If the product doesn’t turn off, press the BBkey ( 11) repeatedly until the set switches off. Wait approximately one second between key presses to give the red indicator lamp (1) enough time to go off and light up again. This will allow you to see whether the product responds or not. 8. Immediatelyafter the product to be controlled turns off, press OK(8) to save the subcode. Note: If you want to assign another type of product than those mentioned on the remote control, begin by entering the code tha... »