Notice LUMIE Bodyclock SUNRAY 100

« Sunray have been shown to improve mood, energy, productivity and the quality of sleep and awakening.* Please read these instructions carefully to get the most out of your Bodyclock Sunray. *Acta Psychiatr Scand 1993 Jul; 88 (1):67-71 www.lumie.com |lumie careline 0845 658 9292 |3 English1Safety !Keep the globe over the bulb, unless the bulb is cold and the lamp unplugged. !Don't cover the globe as the slots in it help lose heat from the bulb. The globe will get warm so keep it clear of anything that might deteriorate in contact with heat. !Always use a 60W E14 (SES) candle bulb. !Keep the Bodyclock away from water and damp. For indoor use only. !Don't open the casing for any reason. All internal parts are high voltage. There are no user-serviceable parts inside. 2Getting started !Remove the 'globe', the cover over the bulb, with a gentle upward tug. !Screw in the bulb ?rmly and replace the globe. !Plug the Bodyclock into the mains. The display will ?ash on and off until the time has been set (or after a power cut). !When replacing the bulb, always unplug the Bodyclock. Spare sunshine neodymium bulbs are available from the Lumie Careline. Youwill need to reprogram the Bodyclock after you plug it back in. 4|www.lumie.com |lumie careline 0845 658 9292 English3The display AM/PM Wake-up Beeper 4The four control buttons Sunset/Sunrise Program Option change 5Setting the clock !Amust be OFF (button depressed). Press Pand hold, will appear followed by the time. !Press +or –until the current time is set. Release P.If you are using the 12-hour clock, the PMindicator will light up when the time shown is between noon and midnight. !To change to 24-hour display, press and hold Pand then press both +and –at the same time. The display will alternate between and each time you do this. www.lumie.com |lumie careline 0845 658 9292 |5 English PMAM ALARM TIME A P6Setting the sunrise (to wake you up) !The wake-up function is set to ON when Ais elevated and is lit up. !The wake-up time is pre-set to 7:00am. To change the wake-up time Amust be elevated and lit up. !Press and hold Pandwill appear followed by the wake-up time. !Press + or - until the wake-up time you want is set. If you are using the 12-hour clock, pay attention to the PMindicator to make sure you set the correct wake-up time! The PMindicator will light up when the time shown is between noon and midnight. 7Disabling the back-up beeper !The beeper is pre-set to ON and will sound at the end of the wake- up sequence. !You know that it's ON because symbol is lit. To turn off the beeper after it has sounded, press Abutton.If the beeper is not turned off manually, the beeper and light will automatically shut off after a while. To disable the beeper, press Ato the elevated position with lit. !Press the +and –buttons together for about 6 seconds until the display reads , a long beep sounds, and the light goes out. !To reverse this, repeat the same procedure until the display reads ,ashortbeep sounds, and the symbol lights up, on release. 6|www.lumie.com |lumie careline 0845 658 9292 English8Setting the sunset (go-to-sleep program) !Press +until the lamp is as bright as you want it. !Press Aso button is elevated and is lit. !The Bodyclock will fade down slowly to darkness. !In the morning, the wake-up sequence will activate at the set time. 9Us... »