Notice KENWOOD CO600

« e complies with European Economic Community Radio Interference Directive 89/336/EEC. 1.Bottle Opener (CO600 series)5.Cutter Blade 2.Drive Wheel6.Guide Pin 3.Magnet7.Knife Sharpener (CO600 series) 4.Lever8.Cord Stowage 1.Plug the appliance into the power supply. 2.Lift the lever to the open position. 3.Hold the can with the top rim resting under the metal guide pin and the can resting on the drive wheel (Fig. 1). 4.Press the lever lightly down to start the motor. The self-starting blade will then pierce the can and commence cutting (Fig. 2). 5.The can will be held fixed in position with the magnet resting against the lid. Large or wide cans may require extra support from the user. 6.Once the can is open, the motor will automatically stop, retaining the can and lid safely in place. 7.To remove, lift the lever whilst holding the can. 8.With the exception of aluminium cans, the lid will be retained by the magnet (Fig. 3). 9.For tidiness, any unwanted length of cord can be stowed inside the appliance. 10.Do not use the appliance to open ring-pull cans. When opening tall bottles, the unit should be used towards the edge of a worktop. 1.Position the bottle with the cap under the front rim of the bottle opener (Fig. 4). 2.Push down the bottle to remove the cap whilst steadying the unit with one hand. 1.With the can opener sideways on, place the knife into one of the recesses. 2.Gradually draw it towards yourself. Then place the knife in the other recess and repeat. Take care not to allow the knife to cut into the body of the can opener (Fig. 5). 3.Repeat this cycle several times in order to sharpen the knife satisfactorily. NOTE: Knives without a serrated edge, preferably carbon steel are most suitable for sharpening. 1.Disconnect the appliance by switching off and removing the plug from the power supply. 2.Lift the lever fully and withdraw the assembly from the can opener (Fig. 6). 3.Wash the lever in hot sudsy water and dry thoroughly. Dishwasher is not advised. 4.Replace the lever in the body. 5.Wipe over the body with a damp cloth and dry thoroughly. If the cord of this appliance is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. Contact the dealer from whom you purchased your appliance. Tento otvírák konzerv znaïky Kenwood slou¥í k otevírání rºznƒch tvarº a velikostí konzerv v domácnosti. Navíc do ¡ady CO600 je zabudován otvírák láhví a také ost¡iï no¥º. P¡i pou¥ívání elektrickƒch spot¡ebiïº je zapot¡ebí dodr¥ovat základní bezpeïnostní opat¡ení, vïetnê následujících: 1. P¡eïtête si peïlivê celƒ návod k pou¥ití. 2.Tento spot¡ebiï nesmí bez dohledu pou¥ívat malé dêti nebo fyzicky oslabené osoby. 3. Nepono¡ujte spot¡ebiï, p¡ípojnou •ñºru ani vidlici do vody, ïi do jiné tekutiny. 4. Nepou¥ívejte spot¡ebiï, je-li po•kozen. 5. Spot¡ebiï je v¥dy zapot¡ebí vypnout ze zásuvky -p¡ed ïi•têním -okam¥itê po pou¥ití. 6. Nepou¥ívejte spot¡ebiï k jinƒm ne¥ vƒrobcem doporuïenƒm úïelºm. 7.Tento spot¡ebiï je urïen k pou¥ití pouze v domácnosti. 8.Dbejte na to, aby si malé dêti se spot¡ebiïem nehrály. Zapojení do proudu P¡ed zapnutím spot¡ebiïe zkontrolujte, zda jmenovité napêtí uvedené na typovém •títku odpovídá napêtí v zásuvce. DªLEITÉ UPOZORNÊN†: Tento spot¡ebiï vyhovuje normê dané Direktivou Evropského spoleïenství 89/336/EEC o rádiovém ru•ení. 1. Otvírák láhví (¡ada CO600)5. ¿eznƒ nº¥ 2. Hnací koleïko6. Vodicí kolík 3. Magnet7. Ost¡i... »